• Jeśli chcesz dodać swojej Alfie charakteru i jednocześnie zaznaczyć przynależność do naszej społeczności – to dobry moment, żeby je zamówić.

    Ramki Alfaholicy

    Szczegóły, zdjęcia oraz informacje o zamówieniu znajdziesz tutaj.

    Nie czekaj, bo jak zwykle schodzą szybko.

Engine splash shield

Which aftermarket would you recommend? I urgently need to replace it and used ones are hard to come by.
 
Last edited:
I bought a shield over a year ago (some aftermarket) it’s been unused, new :) unfortunately I have damaged nut-plates and can’t fasten it properly :(
 
Tell me which Allegro shields you’d advise against. I urgently need to buy but don’t want to buy some junk that won’t fit :eek:

Added after 3 minutes:

Is this shield worth anything? http://allegro.pl/oslona-ekran-pod-silnik-alfa-romeo-159-05-12-jtd-i4466742661.html

Do you think 60 PLN is enough to make a good shield if the original costs probably 500 PLN - which in my view is a bit much. Personally I bought an original used shield, but if I were to buy some aftermarket then =>http://allegro.pl/oslona-silnika-alfa-romeo-159-i4461226227.html
 
Original at ASO they quoted me 750 PLN, fiat-autoparts.com shows about ~1k.
In the above one the only thing that worries me (because it was the only "sensible" aftermarket I found on Allegro before I found a used original) is how the section that is always covered by the thermal shield will behave - will it bulge? Maybe to cut this out and mount thermal insulation from the old shield on rivets. But on the other hand it’s one of the few where they give the material used. The only thing that’s worrying is that the hole spacing may not fit - but with a drill, drill bit you can adapt holes to the original mounts ;-)
 
Last edited:
The price of the original is outrageous!!! I already broke one original, so it isn’t indestructible.

I have Polcar, it’s okay ;)

How long have you had it? Does it not deform?

Added after 2 minutes:

Are shields made of ABS/PVC better or of polyethylene?
 
Last edited:
The issue of tensioners firing after being hit (scuff) on a stone hit me. Not on a 159 but on a 156, but the mounting principle of the "underneath under the engine" is the same - directly to the body. After consultations it was decided to use rubber isolating spacers between the body and the shield.
 
Surely this shield is not armor and the risk of airbags firing is the same as with a plastic shield. If you hit a ski beam there is no difference whether plastic or metal or none.
 
Surely this shield is not armor and the risk of airbags firing is the same as with a plastic shield. If you hit a ski beam there is no difference whether plastic or metal or none.

..only the plastic shield will crack when it contacts a block of ice and the metal one will probably not absorb the force but transfer it to the car body. I ruined a complete original plastic shield in two winters on 205/55r16 tires; if this shield were metal it would probably still be in one piece.. but what would happen to the car is hard to say
 
Sure, the metal won't break, but this one is aluminum not steel and probably won't offer much resistance. One such shield in my previous car didn't survive even one season. The coolest would probably be carbon, but that's another cost.
 
Sure, the metal won't break, but this one is aluminum not steel and probably won't offer much resistance. One such shield in my previous car didn't survive even one season. The coolest would probably be carbon, but that's another cost.

Aluminium is also metal ;-P
 
Amortyzatory
Back
Top