• Jeśli chcesz dodać swojej Alfie charakteru i jednocześnie zaznaczyć przynależność do naszej społeczności – to dobry moment, żeby je zamówić.

    Ramki Alfaholicy

    Szczegóły, zdjęcia oraz informacje o zamówieniu znajdziesz tutaj.

    Nie czekaj, bo jak zwykle schodzą szybko.

Chiptuning

Nothing. Damos is already available and the controller is cracked, so why mess with stupid boxes. Unless there is a guarantee...
Besides, EDC17C69 is already in Giulietta 940 after 2013, which has visited me more than once ;)
 
Last edited:
I bought a box dedicated to the Giulietta 2.2 180 hp
On Saturday tests
 
This controller is also in the Jeep Wrangler 2.8 CRD. As you say sdero, the thing has been known for a long time. What about the warranty? There are dealers who themselves offer tuning. This is the same as LPG installation in the SRT8. The dealer installs it, and where in the manual is there any mention that something like this can be installed? Nevertheless, the warranty is preserved. Besides, what is the problem with flashing the stock map before the inspection?
 
Last edited:
There is a problem. For now I haven’t heard of any Alfa service offering chip tuning and guaranteeing warranty. And changing the software or a box leaves traces. There is a possibility to check that boost pressure was higher than the original the ECU allows, that the fuel dose was different, that the ignition map was changed, etc. Even if you flash one map (ori) onto another, traces remain in the ECU.

- - - Updated - - -

The only solution is to negotiate with a specific OSD (ASO) to turn a blind eye...
 
And changing the software or a box leaves traces. There is a possibility to check that boost pressure was higher than the original the ECU allows, that the fuel dose was different, that the ignition map was changed, etc. Even if you flash one map (ori) onto another, traces remain in the ECU.

You are misleading people. The count for the soft is only tallied when uploading via OBD, and here too better interfaces have options to zero it. For the EDC17C69 ECU, so far you can forget about OBD support. If you restore the original software after a full backup on the bench, no one will see any trace. There will be no information about previous parameters. Either after chip tuning or after a box. The only thing you can notice are traces of opening the ECU.
 
I bought a box dedicated to the Giulia 2.2 180 hp
Testing on Saturday

And how did the tests go? I’m curious where you mounted the box under the hood and how you managed to route the cable while keeping the fuse box sealed. When I looked at the box instructions, there were only photos of what to connect where, there were no pictures showing how and where to mount the box.
 
I’ll add that Giulie Q after 01.01.2017 have ECU protected by a password, which prevents reading and editing parameters. Of course there is a way to bypass this protection but this is another proof that FCA doesn’t want tinkering with the software.
 
You are misleading people. The count for the software is only tallied when uploading via OBD, and even here the interfaces have options to reset it. For the EDC17C69 controller, for now you can forget about OBD support. If you restore the original software after a full backup on the bench, no trace will be seen. No information about previous parameters will be visible. Both after a chip and after the box. The only thing you can notice are marks from opening the controller.

...on the bench... exactly. Soldering, opening, then leaks, moisture... and electronics variation. I’d rather drive stock and forget boosting power than decide on such risky fiddling. I don’t think users who drive year-old or newer Julias would opt for such solutions involving opening the computer... Better befriend someone in the dealership and flash 280 HP in place of 200 HP
 
Last edited:
Most of the new EDC17s are protected. Actually, no manufacturer wants that. Obviously, they can release a more powerful version for more $$ ;)
 
I talked recently with people from Squadra Tuning. I found out that flashing the software from Veloce is possible regardless of the car year. The 200 HP versions from 2016 and 2017 are the same; there are no hardware changes. Based on chassis dyno tests, base Giulia generates closer to 220-230 HP, and Veloce 300 HP. Unfortunately, Squadra hasn’t figured out how to disable ESP.
 
Last edited:
You have to buy yourself a damos, find the switch location and put FF there for the measurement time. Which switch, sorry but I won’t write publicly ;)

- - - Updated - - -

By the way, flashing a 1:1 soft from a controller with different, or rather incompatible HW will end up with a tree on the gauges ;) And the HW will be 99.999% different.
 
Can you elaborate on what exactly HW incompatibility means? I switched to Alfa from Ford, and there you can swap software for example in 1.6 eb from 150 HP to 184 HP or 2.0 eb from 203 HP to 240 HP or from a 2.0 TDCi diesel 150 HP to 180 HP... it’s a piece of cake and half an hour of work at a normal dealership they could handle. Why should it be problematic in Alfa? No differences in engine block and ancillaries...
 
It’s about hardware incompatibility of the controller itself. Moreover, for it to work, usually (at least for the Fiat group, as we’re talking about) you need a complete EEPROM (here there is immobiliser), flash and micro, if such exists, because constructions are different. Of course some producers don’t bother releasing a stronger version and only modify software. Your changes were simply compatible with each other. A better and safer approach is to apply changes from the stronger version to the weaker one instead of flashing 1:1. Do you have original software with the new settings.
 
Your changes were simply compatible with each other. A better and safer approach is to apply changes from the stronger version to the weaker one instead of flashing 1:1. You have the original software with the new settings.
...and surely no service in the dealer will handle this... :( so we return to the starting point. Either bench and opening the computer or software changes as you describe by a chip-taster (...with the note that I don’t know any in PL today) and then trouble at the next visit to the dealer....
 
Again, not every time does a dealer analyze what’s in the computer :) At least in Fiat. Either way you have to open the computer, because I don’t know an interface that handles EDC17C69 via OBD. On the bench it’s not some mega hard controller to hook up. The only thing that’s challenging, and not a big deal, is plugging into the 6th processor leg (in the photo the telescope under the Alfaholics label).

c69.jpg

Look at how it is in the new EDC17 Opels. Here the first time I was probably 20 minutes hooking up ;)

c59.jpg
 
Nothing. The damos is already available and the controller cracked, so why mess with dumb boxes. Unless there’s warranty... Besides, EDC17C69 is already in the Giulietta 940 since 2013, which has reached me not once ;)

Exactly, the warranty is what certainly makes some people gravitate toward buying a box. Theoretically you can arrange with some dealer that they turn a blind eye to tinkering with the software, but in reality you don’t know how they’ll react if there’s an engine fault... I know you’re not a fan of boxes, but could you share your opinion on the Novitec box as a temporary solution while waiting for the warranty period to end?
 
Yes, I’m not a fan of BOXes. But when there’s no way out... I haven’t compared them against each other to express an opinion on which engine parameters are best. I’d be biased. I don’t want to express an opinion on the basis of “it suits me”.
 
Amortyzatory
Back
Top