• Jeśli chcesz dodać swojej Alfie charakteru i jednocześnie zaznaczyć przynależność do naszej społeczności – to dobry moment, żeby je zamówić.

    Ramki Alfaholicy

    Szczegóły, zdjęcia oraz informacje o zamówieniu znajdziesz tutaj.

    Nie czekaj, bo jak zwykle schodzą szybko.

[Giulietta] Chiptuning.

I haven’t measured with the box exactly, but the difference is noticeable. PowerBox Elite
 
If anyone is interested I have a Racechip S for sale under warranty for a Giulietta 1.4 MA 170 hp. I’ve saved up a bit and I’m going for ECU remap + IC from QV + DV+ GFB, let’s see how much the gain will be.
 
Last edited:
Hey, I have a question about chiptuning a Julka with 120 hp. With such modification using software + IC and increasing power to 145 hp will the brake system need to be changed? As I understand it, in a 120 TB the discs are 281 mm, will they with standard calipers be enough or would it be better to switch to 305/330 mm and four-piston calipers?
 
The brakes like you have in the 1.4 TB were, for example, in a much heavier 159 1.9 JTDM 16V 150HP, 1.9JTS 160HP or 2.2JTS 185HP before the facelift (albeit 305mm but the car is much heavier). The size and type of brakes are not chosen by the power of the car, but by how heavy the car is, how often you brake, from what speeds, etc. On the track you can even have 6-piston (calipers) but steel ones will wear out quickly (example Giulie Q in versions without ceramic brakes which they tried on track). In my Giulietta Veloce After 20 minutes of laps on the go-kart track in Kielce (it was a few degrees C) the brakes smoked (330mm 4-piston, rear 320mm single-piston).

With my wife’s 1.4TB tuned to 147HP the stock brakes remained, of course.
For simply changing the software to 145HP you don’t need to change the IC, that’s only if you want to change the turbo and make a lot more.
 
...The size and type of brakes are not matched to the car’s power, but to how heavy the car is, ...

With my wife’s 1.4TB tuned to 147HP the stock brakes remained, of course.
For simply changing the software to 145HP you don’t need to change the IC, that’s only if you want to change the turbo and do a lot more.

Very nicely the guy described the topic of changing brakes.
Another matter, but I think obvious too, the IC doesn’t give horsepower as many common opinions say. It allows them to be kept at the same level through more effective heat exchange, which the stock IC may not cope with under bigger/longer loads like mods or track driving.

Although a larger IC, even without mods, can add +10 to the car’s swagger ;)

Another question - has anyone used a chip on a 1.6 105 km jtdm?
 
IC okay. The question what ma_ucin_88 actually means, whether he only wants to increase power to use a bit on the road, or plans to go crazy. In the first case stock brakes and IC will be fine, in the second IC, brakes need replacement, probably bigger turbo, stiffer suspension etc.

1.6jtdm I don’t know, though there was a 120HP version and knowing life 105HP is just software-limited 120HP, so there should be a lot of room with software. colleagues please confirm or add something if hardware differences.
 
1.6jtdm I don’t know, though there was a 120HP version and, life being what it is, 105HP is just software-limited 120HP, which can be increased further, so there should be a lot of room in software. mates please confirm or add if there are hardware differences.

Here, as far as I’ve looked into it, there are two differences, the first almost certainly being a turbo without variable geometry. The second difference between 105km and 120km is the single-mass flywheel instead of a dual-mass one.
This chip is needed solely for everyday nicer driving, so I won’t chase the turbo’s end to blow at 140+ by any means.
I’m curious if the engine caused any problems after the tune or if the tune itself causes no surprises, what to pay attention to.
 
epsonix, huge thanks for the information. I started getting interested in cars about 2 months ago, i.e., since I started looking for a Julka to buy, and the road ahead is long. But now I’ll know that the braking issue in road driving relates more to the car’s weight.
Definitely increasing power in the 1.4 TB is to be used on the road, I especially want the acceleration to be a bit better. Can we generalize that thisNm parameter is responsible for that?
alehandro you convinced me with that argument, +10 is always cool. Since IC doesn’t add power but can improve heat exchange, even more so :)

And just visually, does changing the calipers to Brembo involve changing discs to 305? Are there smaller than the 4-piston ones I often see with 330mm discs?

Regards,
Marcin
 
If you don’t want to build a race car, buy yourself a Magneti Marelli box http://www.en.magnetimarelli-checkstar.pl/tuning-box,11,3,135I’ve driven with such a box, the engine revved higher, it pulled really well, on the highway overtaking was definitely a plus.
You’ll do it at a small cost and safely.
I do not recommend chip-tuning the ECU with such modest expectations.
 
And I, for my part, don’t recommend the box and low expectations have nothing to do with it. ma_ucin_88 If you’re in Kielce I suggest calling conmira, arranging a proper tune with braking, driving to Kraków and getting it done properly for actually less money. For now, if your brakes are in good condition leave them as is, maybe fit some good pads. After that, it still won’t be a speed demon, so if you won’t be pushing hard, they’ll be enough.
 
68oct thanks for the link, I’ll definitely read up on that. I was thinking a bit about some box because the installation seems simple, not invasive and you can always unplug it. Which engine did you use this with? ML3 (multiair?), I’m in Kielce, sometimes in Krakow and I’ve just heard that capable people are in the area. I’ll check out that place. It’s surely worth going to the recommended spot rather than searching via Google opinions ;)

As for the brakes, we’ll see when I buy Julka ;) Thanks, for all the information!
 
I wired a box to a T-Jet 120HP. On Magneti's site you’ll find info for which engines it fits and which version. Logging into the box allows modifying the factory-loaded map, optionally you can buy a remote that changes, activates, deactivates them. It was a nice gadget, designed by Magneti which back then was part of FCA. I bought it from a dealer.

Sent from my SM-G975F using Tapatalka
 
I wired a box to a T-Jet 120HP. On Magneti's site you’ll find info for which engines it fits and which version. Logging into the box allows modifying the map loaded by the factory, optionally you can buy a remote that changes, activates, deactivates them. It was a nice gadget, designed by Magneti which back then was part of FCA. I bought it from a dealer.

Sent from my SM-G975F using Tapatalka
Don’t write nonsense because the box doesn’t modify any maps, it only deceives the sensor readings to the ECU.
 
Don’t write nonsense because the box doesn’t modify any maps, it only deceives the sensor readings to the ECU.
http://www.racingforum.pl/WiAecej-mocy-z-MAGNETI-MARELLI-Teraz-moesz-zrobiAe-to-sam-t110353.html

Before you write that someone is talking nonsense, buy it yourself and see what it enables.
Most currently installed or offered boxes have custom maps loaded, they even tune them for a given car.

https://www.google.com/url?sa=t&sou...FjAAegQIBhAC&usg=AOvVaw2xXv8GJZ1Pna6i_CQIxlrS
 
Last edited:
http://www.racingforum.pl/WiAecej-mocy-z-MAGNETI-MARELLI-Teraz-moesz-zrobiAe-to-sam-t110353.html

Before you write that someone is talking nonsense, buy it yourself and see what it enables.
Most currently installed, or offered boxes have custom maps loaded, they even tune them for a given car.

Sent from my SM-G975F using Tapatalka

Of course you’re talking nonsense. Piotriix is right, because what you flash are values for how much the ECU should be deceived and to what extent. It’s a bit more complex than just op-amps, because they have one simple processor. And of course amplifiers, aimed at adjusting the input so the ECU doesn’t throw errors. Simply, the potentiometer has been replaced most often with an Atmega or a simple ARM. It’s still a "resistor", just more electronic. It’s only falsifying the given range by a certain amount. While in diesel you can maybe permit something, in PB I wouldn’t do it. I’d rather drive with factory settings. And do you know why you choose a car model? Because it’s only about matching the plugs or cable lengths.

On the site you gave - "The pedal module ME200T is also available in the offer, which modifies the signal reaching the ECU by simplifying the vehicle acceleration. An incredibly simple Plug and Play installation without tools." :)

I threw a bunch of this in the trash, and the worst ended up like this https://tiny.pl/r23x1
 
In my Giulietta Veloce after about 20 minutes of laps on the kart track in Kielce (it was + a few C) the brakes (330mm 4-piston, rear 320mm single-piston) started smoking.

epsonix, please tell me, was the driving really aggressive and did it smoke only, or did it overheat and you had to replace something? Also did you notice the brake pedal got "soft"?
Was this in Miedzianna Góra on the middle section of the track or some other typical karting one?
Cheers ;-)
 
on the middle loop in Miedziana Góra. Driving on Dynamic (needed Race), at max. The pedal behaved normally. On the disc there was a bluish tint. I didn’t replace anything, brakes work well so probably I didn’t push too far. It smoked, perhaps I overdid it too - I’ll clarify a bit more, it smelled more (very long after stopping).
 
Okay, more precisely, you can flash files that deceive the controller and control the degree of deception with a remote.
The tuner does not deceive, he permanently modifies it; if something goes wrong, he’ll tell you, after all you signed a contract with a clause, you are aware of the potential risk and take it.
The guy wants to increase power by 20HP, an honest tuner won’t do it, because most cars come with such a gift from the factory, it’s enough to spoof the car. And if something goes wrong, the guy will pay for a replacement engine or a rebuild costing tens of thousands.

I think that, until the degree of deception is handled by a company that produces the controllers, the automaker is much safer than its tampering (jet) and "modding" by guy A or B, certainly safer than buying maps on Allegro or that "e-tuning" equivalent.
The truth is, the type of cable depends on the box; there are others for diesel and others for different fuels, depending on control or plugs.

I haven’t driven with a box for several years, I won’t defend it because it doesn’t make sense.
I think the box is a decent solution for a customer who wants to improve car performance without changing it permanently (nonsense, you can always revert to stock, only depends on cost), in case of a box to return to stock you just unplug the cable.
In Poland the boxes have a reputation similar to Alfa Romeo, plug it in, alfa with the box it’s mega cringe on the neighborhood.

Spectacular shredding.
Box MM doesn’t cost 200 PLN, I think you wouldn’t shred it, you’d sell it :-P

Cheers!
 
Last edited:
The tune controller tuner doesn’t deceive, he modifies it permanently, if something doesn’t work out.

You see, you need to pick a tuner who doesn’t have something coming out but someone who knows what he’s doing. Even here on the forum there are several such people. Unlike those who turn a potentiometer, or flash these pseudo maps, the tuner will take measurements, logs.
You write that you don’t drive with the box anymore. Do you have any measurements after the changes? Not even the values, but how you would obtain them if during ECU diagnostics it provided you with falsified information. Hmm... so what to choose - tuning by guess, or based on real data? Did MM provide you with such a tool? I’d love to check it out.

The guy wants to increase power by 20HP, an honest tuner won’t do it, because most cars have such a gift from the factory, it’s enough to spoof the car.

What do you get as a gift? What nonsense. I don’t know a car that has +20HP and no drawback. Yes, there is no such thing as a “high-power series.” Also + and - are a sign of a flaw.

I think that, until the degree of deception is handled by the company producing the controllers, the automaker, it’s much safer than tampering (jet) and "modding" by guy A or B, certainly safer than buying maps on Allegro or that e-tuning equivalent.

1. A T-Jet isn’t glued. Unless someone uses a clone/Chinese one. It goes into service mode, via OBD or VR.
2. e-tuning is done based on the logs of a given car, i.e., for that car. And this should be distinguished from off-the-shelf solutions.
3. Have you ever wondered why that manufacturer doesn’t publish results from measurements of their cubes? Only Paint pictures and marketing drivel. Funny, isn’t it? )

I think the box is a nice solution for a client who wants to improve the car’s performance without changing it permanently (nonsense, you can always revert to stock, it depends on cost), for a box to return to stock you simply unplug the cable.

In the case of tuning, you just go to a tuner. Flash the stock.


Spectacular burnout.
Box MM does not cost 200 PLN, I think you wouldn’t burnout it, you would sell it :-P

Yes, you’re right, the MM box goes back to the owner, because he can always resell it. There are eager buyers :)
 
@sdero
He still doesn’t get it and thinks that the box is flashing something into his car[emoji16]
 

Related threads

Amortyzatory
Back
Top