• Jeśli chcesz dodać swojej Alfie charakteru i jednocześnie zaznaczyć przynależność do naszej społeczności – to dobry moment, żeby je zamówić.

    Ramki Alfaholicy

    Szczegóły, zdjęcia oraz informacje o zamówieniu znajdziesz tutaj.

    Nie czekaj, bo jak zwykle schodzą szybko.

[Giulietta] Chiptuning.

There isn’t one in Poland, but anyway it isn’t something that affects how the box looks at all, because I still have over 100k km. I doubt it would be something bad, because then no one would give a warranty either; additionally there is electronic protection against engine overload, it monitors some parameters and after they’re exceeded it disables the box and the car returns to stock. It would be worth going to a dyno and doing stock tests and after connecting the box – to see how it looks in real life, but as I wrote, it raises the stock by a percentage, so the final power depends on the initial stock.

I didn’t want to discredit the box or anything, I have nothing against it, I just wanted to point out the lack of warranty in Poland, in case you missed it on the seller’s page and it would be important for you :) My favourite version is 2. From what I understand it works by modifying the boost reference (and the atmospheric pressure), so the turbo breathes more. And you can deliver more fuel.
 
Cinek wants 1700 zł for tuning. On balance it’s cheaper, and you can probably sell the Box later.
The only reason to buy MM is to control with a remote – then the set costs 1385 zł, because in the option without a remote it’s cheaper to buy a RaceBox by more than half.
 
brother, the question is about two specific boxes, not a tuner, ok, just for clarity, so as not to blur the topic. One prefers a tuner, the other a box, and each solution has its pros and cons, and what you will drive on is your choice.
 
Lechtak, did you do AFR measurements at the dyno? How many kilometers did you run with this box? The manufacturer states an increase in fuel consumption; what was it really? Regards P9
 
I used MM in Mito 1.4 135 HP had an power increase of about 30 HP, unfortunately I don’t have a printout. Using the remote I set three modes. I didn’t notice an increase in fuel consumption.
 
On alfaowner.com a few people have packed racechip into 1.4 Ma and into QV. In general they write that the difference is very noticeable, one guy took the stronger one to 1.4 Ma supposedly at 210 HP and wrote that it seems there is even more :) but of course no one has a chart... Since there is a 14-day return policy, you can always measure the car before and after and if instead of 210 HP you have 180 then return :)
Overall I didn’t find anyone there who had problems with this race chip, only that they have mileage of 20-50k km. I for mine with 4x more I would rather have safe tuning on a dyno.
 
Overall I didn’t find anyone there who had problems with this race chip, only that they have mileage of 20-50k km. I for mine with 4x more I would rather have safe tuning on a dyno.

Hard to have problems when the racebox is made by a professional company and it has protection against engine overload and it’s not surprising that it has protection when someone gives a two-year engine warranty up to 5000 euros, obviously for a car under 100,000 km - in my opinion that is still a big loophole, because no tuner in Poland gives a warranty on the engine even for the time of the software work, not to mention further use - unless I’m mistaken? does anyone give?
Software made by a tuner doesn’t offer such protection, it won’t disengage when engine parameters are exceeded and it always depends on the tuner’s knowledge and the head of the person driving the car.
Besides, do you think the engine after 100,000 km cannot withstand such loads as the one with 30 or 50,000 km, that’s nonsense - I bet that 70% of tuned cars in Poland have over 100,000 km on the odometer.



but of course nobody has the chart..
Having a dyno measurement done costs money and not everywhere in Poland do you get a chart for free, often you have to pay extra for a printout, and not cheap.

And referring to the dyno chart, it would indeed be some evidence, but is a dyno the only reliable kind of measurement?
What about road tests, like acceleration tests - flexibility, top speed - probably that tuning is supposed to improve these parameters, what good is a car with 200 Ps if it doesn’t translate into real performance.
Besides, a dyno measures max power and torque and their traces under defined conditions, a given gear - sandal on 100% and driving, and what about undefined conditions, reduction, acceleration from a given speed in a given gear, here only road tests remain. Put a stock car against one with a box, then compare it with one after soft from a good tuner and that would be a real comparison.
 
Last edited:
What protections are you talking about? After all this module has no connection to the ECU.
This is a scam module and that’s that.
Protections are in the ECU.
I’m more interested in what AFR values are at the open loop. The price is quite attractive even with the warranty surcharge.
But whether it’s safe and real, who the heck knows

P9
 
What protections are you talking about? After all this module has no connection to the ECU.
This is a scam module and that’s that.

Please read the product description, it’s hard not to believe that the box deactivates during engine overload, it has access to the sensor maps and atmospheric pressure sensor - and thus the temperature in the charge air system, you’ll burn and overheat the charging system - the box will shut down and you’ll drive on stock.



I’m more interested in what AFR values are at the open loop. The price is quite attractive even with the warranty surcharge.
We need to test it else there’s no way, the measurement in NL is 75 euros - an hour on rolling road 150 euros + the equipment fee - also you need to know how to use it.
Ok, you can do it in PL, just can you persuade some tuner to do it - I bet they’ll agree for a rate that discourages you.
By the way I checked in NL they offer three levels of software editseco 177Ps 260Nm. normal 203/300 and extreme 211/320 - prices are 300/400/500 euros.
Which tuner in PL makes a 1.4 Ma to 211Ps/320Nm - I’ve seen one such chart - the rest around 190/200Ps and 290-305Nm, about software, of course.

Racebox aims to increase the car’s power proportionally to stock and improve the car’s dynamics, after all at least to me it’s about ease and driving comfort and not grinding the Alfa at 4,000–6,000 rpm. And the price, even in the intermediate option, is still 600/700 PLN cheaper than software - and probably the option for me with 130 euros will be enough.

I posted a question on the forum, because maybe someone already installed and drove, because foreign forums give only positive impressions nowhere did I see posts like it throws errors, doesn’t give power, or something similar.
However there are a trillion tips go for software because this box is evil and the engine will fall apart in two, tuners have one pitfall and there is internet chatter, and with a box it would be different?
 
The tuner making the wrong map can very quickly mess up, especially with petrol. The box is safer to plug in, because the air-fuel ratio is still measured by sensors. If something goes wrong the check engine will come on.
 
And with the chip this isn’t measured?

P9
 
.
I’m more interested in what AFR values are at the open loop. The price is quite attractive even with an option for a warranty. But whether it’s safe and real, who the hell knows

P9

This is a serious problem.. Few companies making their own map want to bother with AFR and even better - measuring EGT in the manifold. Because that’s what this is about, to avoid frying the head. EGT is something tuning guys want to measure, but when they make a new DP.
 
This is a serious problem.. Few companies making their own map want to bother with AFR and even better - measuring EGT in the manifold. Because that’s what this is about, to avoid frying the head. EGT is something tuning guys want to measure, but when they make a new DP.
So these measurements are not performed during regular soft editing in TB?
 
So these measurements are not performed during regular soft editing in TB?

From those places in Warsaw that I know, they measure AFR by observing the readings of the stock sensor (i.e., if the ECU doesn’t throw a check, it’s okay), and no one wants to hear about measuring EGT in the manifold - because for them chip tuning is just an interaction with the car via the diagnostic port/ECU, without messing with the manifold... Another thing is that you don’t hear about 1.4 MA pistons tuned to 200 HP “by eye”, but that’s good - the head is solid, and you can probably squeeze a bit more out of it.
 
Cinek always measures AFR with an O2 sensor inserted into the exhaust, while EGT from what I understand is estimated by the program, probably also based on the exhaust sensor and probably some model for a given car. Regarding EGT I don’t know for sure, in case ask Cinek.
Here’s proof - tinkering on wife’s Giulietta - there is a sensor in the exhaust (photo from Cinek’s Facebook):
12184023_773114979465112_7139130991447441803_o.jpg
 
Last edited:
Amortyzatory
Back
Top