lookam do elearna, jakaś akcja updatu ALFM w autach 2024, do tego inna sprawdzenie regulacji manualnej i działania ewentualnie wymiana lamp MY23 marzec-listopad a to o której tu piszemy to to:
1
Turin - 14/04/2022
Safety Recall (SR) 6439
AFLS (Adaptive Front Light System)
On a batch of Alfa Romeo Giulia vehicles Adaptive Front Light System (AFLS), the
automatic headlight position sensors may not have been calibrated and, therefore, the
function does not comply with the requirements of ECE R48. As a result, the headlights
may not be adjusted correctly when the load or the load distribution on the vehicle
changes.
Therefore, action must be taken during pre-delivery inspections on vehicles still in stock
operating according to the operating cycle to upgrade all vehicles.
Customers will be contacted by registered mail letter (attached)
BRAND ALFA
MODEL
620 - GIULIA
630 - STELVIO
PRODUCTION PERIOD
620 - GIULIA - from JANUARY 2021 to
FEBRUARY 2022
630 - STELVIO - from NOVEMBER 2020
to FEBRUARY 2021
CONCERNED VEHICLES All vehicles with chassis number listed in
SiGi.
PROBLEM / FAULT No automatic headlight adjustment.
PLANNED OPERATION AFLS module learning procedure.
SPECIAL TOOLS wiTECH 2.0 with registered micro MDP
OPERATING CYCLE
Module learning procedure (AFLS)
Run the AFLS (Adaptive Front Light System) module learning procedure as described.
For all service operations that require flashing the software in electronic control
modules, it is necessary to connect a battery charger to guarantee the nominal voltage
of 12.5V 10Ah for the entire duration for the update in order to ensure the correct level of
electrical power during the operation.
At the end of the learning procedure, reset any errors (DTC) that may have been
generated, as shown on the All DTCs tab.
• Using the diagnosis equipment, access vehicle view, select the AFLS (Adaptive Front
Light System) module and open the Miscellaneous Functions tab.
• Then select "AFLS learning” on the tab"
Read all the instructions and warnings displayed during flashing.DO NOT continue
with subsequent steps without first completing the actions requested at each step
At the end of the process, save the Report suggested by the system for later
investigations.
If the flashing process is interrupted or fails, it must be restarted.
• At the end of the flashing procedure, reset any errors (DTC) that may have been
generated in other modules as a result of the flashing. These will be shown on the All
DTCs tab.
• Disconnect the diagnosis equipment.
• Remove the battery charger from the vehicle.
• Hand the vehicle back to the customer
szczerze to nie wiem czy ta procedura to to samo co w MES czy AlfaOBD ta System Calibration.
