• Jeśli chcesz dodać swojej Alfie charakteru i jednocześnie zaznaczyć przynależność do naszej społeczności – to dobry moment, żeby je zamówić.

    Ramki Alfaholicy

    Szczegóły, zdjęcia oraz informacje o zamówieniu znajdziesz tutaj.

    Nie czekaj, bo jak zwykle schodzą szybko.

Steering angle sensor.

Joseph-S

New
Joined
May 29, 2020
Messages
33
Car
Stelvio
Hello
After replacing the steering rack I have a problem with calibrating the steering angle sensor. In the ABS section -> Continental ABS MK C1 -> Parameters -> Steering angle it shows the value 2048 and it does not change even when turning the steering wheel. During calibration attempt an error pops up: Bad conditions to perform test. Disconnecting the battery causes the value from 2048 to change to 0. Calibration also cannot be performed. There is no reaction. If someone has dealt with this topic please provide guidance.
Regards.
 
A charged battery ??? Because calibration often fails when the battery is already running low

Posted from my 21081111RG using Tapatalka
 
how do you have the steering wheel set to 0 zero degrees ???
The issue is that when I turn the wheel the angle does not change. When I connect the battery and plug it in it shows zero and calibration cannot be performed. After turning the wheel from extreme left to extreme right in the steering angle calibration field instead of zero a constant value 2048 appears. Any suggestions??
 
The issue is that when I turn the wheel the angle does not change. When I connect the battery and plug it in it shows zero and calibration cannot be performed. After turning the wheel from extreme left to extreme right in the steering angle calibration field instead of zero a constant value 2048 appears. Any suggestions??
Have you tried to drive the car and with the engine on at idle full lock left and right

Posted from my Redmi Note 7 using Tapatalka
 
Another question: is the battery charged ??

Posted from my 21081111RG using Tapatalka
 
Remove the steering wheel and see if someone has manhandled the spider (potentiometer?). Once you remove it, take a multimeter in hand and check the steering angle sensor potentiometers.

Posted from my 21081111RG using Tapatalka
 
Remove the steering wheel and see if someone has tampered with the spider. Once you remove it, take a multimeter in hand and check the steering angle sensor potentiometers.

Posted from my 21081111RG using Tapatalka
And what values should the potentiometers have??
 
Hello
Does anyone have contacts for someone or a company that handles calibrating the steering angle sensor (preferably around Lublin). A problem has arisen - after replacing the steering rack the steering angle sensor cannot be calibrated. The value it shows is -2048. Connecting the old rack where it worked also shows the same (turning the steering wheel and checking in the field Steering angle - the value does not change). The calibration attempt with Mes shows the error "Bad test conditions"
Thank you
 
Amortyzatory
Back
Top