• Jeśli chcesz dodać swojej Alfie charakteru i jednocześnie zaznaczyć przynależność do naszej społeczności – to dobry moment, żeby je zamówić.

    Ramki Alfaholicy

    Szczegóły, zdjęcia oraz informacje o zamówieniu znajdziesz tutaj.

    Nie czekaj, bo jak zwykle schodzą szybko.

[Giulietta] Operational tips

No problem, but I’m temporarily in Croatia :)
The luggage rack works fine, but I couldn’t get rid of the resonance at around 120-130 km/h.
 
Don’t you have the feeling, when taking tight curves, that the rear end is "floating"? I noticed it yesterday and today - a feeling that the rear is running outwards of the turn - I must admit, quite unpleasant...
 
Dont you have the feeling, when entering tight bends, that the rear end is "floating"? I observed it yesterday and today - the feeling that the rear is running outward of the bend - I must admit, quite unpleasant...

And that’s how it’s supposed to be ;) Take a lap on some track, ride it at the limit, you’ll get used to it and see that it "grips", you simply adapt. You’re used to the 147 where it drove with the front, with the Giulietta you steer the whole car. Especially in dynamic mode it can be so.
 
Somehow I preferred the 'bite' of the 147 into the corners... Maybe it’s a matter of getting used to it. If I feel it’s under control, it might even be pleasant :). For now I have few opportunities to push it on a bend, plus I don’t push it too hard because the mileage is still low.
 
Gentlemen, I have similar impressions. Earlier I was driving a 147 and now, a few times in dynamic mode, I thought my adrenaline would explode out of my ears ;)
 
From my experience (short): 147 - it drove great; GT - so far I feel a rush of adrenaline when I think what it could do; Giulietta - outdoes all the rest (the duct is a wonderful invention) you just have to learn when and how much you can press the accelerator in a turn.
 
Hello
For a long time I’ve been wondering what the second position is for in the wiper speed setting (the first position is intermittent operation and the second is also intermittent). I didn’t notice any difference (I didn’t measure with a stopwatch) besides the pictogram.
And immediately, another issue: can the parking lights be turned on (low beam turned off) with the engine running. Both systems (wipers, lights) manual. Thanks and regards
 
Unfortunately I have to refer you to the user manual. Depending on the model and equipment. In my "first" gear, the wipers auto with rain sensor and respond to the intensity of precipitation. The same goes for daytime running lights, setting is possible through the onboard computer.
 
Last edited:
Parking lights turn on with the stalk after turning off the engine

That I know, I asked how to turn it on without turning off the engine. (Perhaps impossible) As for the wipers, it is written that the first is intermittent slow, the second intermittent faster. Unfortunately I did not observe such behavior. Regards
 
Parking lights only from the computer.
Passing with the stalk both when on and off. The same long one.

That’s decent, but the fact that there is no way to adjust the brightness of the gauges and the computer screen is already some kind of absurdity.
 
You can adjust the backlight..

It’s just that the white light is adjusted together with the red one. So you have to choose whether the white should be a bit anemic, but red is OK, or white OK but red requiring wearing sunglasses at night.
Nice that at least the dimmer has independent settings depending on whether the daytime running lights are on or not.
 
+ and - from the menu. Imho it works quite OK. The super thing is in Toyota (and probably many others don’t have daytime lights). So when you turn on the dipped headlights during the day, what to do in such a situation, everything dims and in bright daylight you can’t see anything at all.
 
Last edited:
We use the indicators when the engine is off while the car is stationary. Right or left side. This is described in the manual.
 
Hello
For a long time I’ve been wondering what the second position in the wiper speed setting is for (the first position is intermittent operation and the second also intermittent). I didn’t notice a difference (I didn’t measure with a stopwatch) except for the pictogram.

I had a similar impression. But recently I’ve driven several thousand kilometers in truly Alpine weather, i.e. downpours. The speed of the wipers is the same, but the frequency in this second position is a bit higher. To the point that with a certain intensity of rainfall it made a difference whether it was the first or the second position. Although I admit the solution isn’t perfect. I’d prefer the first position to have a clearly lower frequency. In light rain you have to completely turn off the wipers and wipe the windshield once every few seconds by lifting the stalk. A customization is missing.
Another thing is the operation of the rear wiper with the frequency of 1/2 of the front. That’s also too often, and you have to wipe the rear window from time to time by turning the bushing on the stalk, which is a less ergonomic solution (you have to loosen your grip on the steering wheel) than in other solutions where it’s done by moving the stalk. You can start the rear wiper by pushing the stalk, but each time you also waste washer fluid.
On the other hand I can’t get used to the fact that the high beams turn on and off by moving the stalk in the same direction as the turn signal. It’s half-bad that if you want to flash you just give a quick flick. Worse, the whole mechanism is so imprecise that turning off the high beams sometimes also toggles the indicator for a lane change, which shocks drivers coming from the opposite direction.
Little things, but in tougher weather it’s annoying when you focus on the road and fight with the switches.
 
Ha the wipers were a problem that also annoyed me. Positions 1 and 2 (intermittent) shorten the time with increasing speed; at a standstill they work the same. In the 2nd position the pause shortens a little more. Anyway, the gimmick is crap (or rather its adjustments), as both times are too short when it’s drizzling. I solved this by adding a self-habricated module on a microcontroller.
And now in the 1st intermittent position I have a learning mode: I turn to the 1st intermittent position: by default I have 6 seconds (constant, independent of speed) which I can change by pulling the washer stalk. The first pull = a wipe of the wiper, a single “beep” from the buzzer, start of the time-memory. I wait until I need to wipe the windshield again and I pull the washer stalk again.
The second pull = a wipe, double beep, stop of the time-memory. From then on the wipers run with the remembered interval until I pull the stalk again to start “learning” or turn the ignition off (then it restores 6 seconds). There are also end values added
The inconvenience might be that the washer doesn’t operate in this mode (couldn’t solve this with this type of installation) but so far it hasn’t bothered me. The other modes are preserved (though I replaced the second mode with the first) and no gadgets like buttons and knobs are added. I’ll someday post a video.

In the beginning I was also annoyed by the fact that it turns on with the knob, but there’s a benefit: the "panic" function is available all the time without having to switch the wiper gears.
I also wanted to use this module for automatic engagement of mode D after starting and maybe a few more things (there are plenty of programmable free outputs in the processor), but I have no ideas for now.
 
Last edited:

Related threads

Amortyzatory
Back
Top