• Jeśli chcesz dodać swojej Alfie charakteru i jednocześnie zaznaczyć przynależność do naszej społeczności – to dobry moment, żeby je zamówić.

    Ramki Alfaholicy

    Szczegóły, zdjęcia oraz informacje o zamówieniu znajdziesz tutaj.

    Nie czekaj, bo jak zwykle schodzą szybko.

Headlight sprayers

Czaro

New
Joined
May 5, 2019
Messages
181
Location
Trójmiasto
Car
Giulietta 1.4 MultiAir 170KM
Hi everyone, the headlight sprayers aren’t working, there’s no power reaching the pump, the fuse F09 is OK. Where to look? Is there a harness going into the bumper that you need to access by dropping the bumper? The front/rear window washers are working normally.
 
A trivial question, but better to ask and rule it out than unnecessarily fiddling...
Do you have your low beam headlights on? Otherwise they won’t work...
 
By the way in this thread - when they were still working (and hopefully will again soon) the lack of a time delay is annoying. In the two Lancias I had, Delta and Thesis, you’d pull the stalk to max for about 1 second and the headlight washers wouldn’t engage. Here, every spray on the windshield floods with liquid.
Is it a relay design issue or does the ECU send the signal? Anyone have ideas for a modification?
 
Can you describe step by step how to do it?

View attachment modernizacja spryskiwaczy świateł.pdf a description of how to make a delay when spraying the headlights. Of course we don’t have to connect to the body, you can make these connections under the hood, you need to access the wire from the low beam and the wires of the windshield washer pump and the fuse box.

As for relay T02, you can remove it but then there will be an error in the computer "windshield washer relay" or at least cut off one pin of the contact so it won’t function and there won’t be an error either.
 
Last edited:
An error won’t appear on the dashboard (less important) but it will be stored in the computer memory after connecting Mes or alfaobd
 
The problem turns out to be strange and interesting:
1. Fluid and lights are present – let’s eliminate this point.
2. The relay was swapped with another identical one in the box. No effect.
3. The circuit was momentarily shorted at the relay place – there is an effect, the washers work.
4. It was checked whether the control signal reaches the relay during the spray attempt – it does not reach.
5. Diagnosis – something must be wrong between the comfort module (where the fuses are near the driver) and the relay.

And now the most interesting:
6. After completing the diagnostics, the car could not start, because the fun with the washer and the light absorbed energy of the battery (when starting the lights dimmed and LED indicators – classic sign of a discharged battery) which is possible, because the battery hadn’t been replaced and is 6 years old.
...and cherry on the cake:
7. The car was started with a portable jump starter to the battery, then it left the hall.
8. After leaving the hall the lights were turned on and another attempt at the windshield washer lights... and they worked!
What could have happened that it fixed itself? Resetting the body module with a voltage drop? A weak battery might be the cause (which seems illogical)?

Where is the problem?
 
I have a very similar problem in another car. Every so often the power steering or immobilizer doesn’t work.
After disconnecting the battery for a moment, everything returns to normal.
Suspect the body is at fault, because everything except it has been checked and is ok, so yours might be similar. Next time your washers fail, disconnect the battery and see if it helps.
 
Last edited:
I have a very similar problem in another car. Every so often the power steering or immobilizer doesn’t work.
After disconnecting the battery for a moment, everything returns to normal.
Suspect the body is at fault, because everything except it has been checked and is ok, so yours might be similar. Next time your washers fail, disconnect the battery and see if it helps.
Perhaps the culprit is indeed the battery? In a car with start-stop system this could even make sense. If the battery is weak, it disables start-stop, but the mumbled power is even weaker, the ECU then cuts off other systems.

However, what’s happening with you, that even the power steering stops working, may be caused by something other than in my case.
 
SUMMARY (as of today)
The battery has been removed and recharged with a charger.
No errors, start-stop obviously started working but there is an off switch so it’s ok.

The windscreen washers, as they fixed themselves (as mentioned earlier) are still functioning. The dealer is surprised as well. After a brain-storm, it seems that a weak battery causes the control unit to start cutting off less-priority comfort systems.
Note: this theory is not definitively confirmed but so far that’s what it looks like.
 
gentlemen I’ll chime in on the topic: the situation is that when the washer fluid is filled up to the red line, the fluid starts dripping under the car, specifically from the right and left Xenon nozzle pumps, only when the fluid level is at the black line does it stop and it doesn’t leak.. and I wonder if the pumps are at fault or too much fluid poured into the reservoir and that’s why the pumps spray? because the fluid intake is 5L from what I know, but this 5L is counted with the tube all the way up or only in the reservoir at the bottom without counting the tube? because I don’t know why I insisted on filling to the very top because that tube probably serves only as a funnel to pour fluid into the bottom reservoir and maybe that’s why the fluid comes out of my pumps when I fill to the very top of the tube? can anyone help?
 

Attachments

  • 123.jpg
    123.jpg
    168.3 KB · Views: 34
  • er.jpg
    er.jpg
    168 KB · Views: 25
I always fill up to the cap and I haven’t noticed any leaks...
another thing, I wasn’t paying attention whether there are any leaks...
next time I (will) fill it I’ll take a look
 
Amortyzatory
Back
Top