• Jeśli chcesz dodać swojej Alfie charakteru i jednocześnie zaznaczyć przynależność do naszej społeczności – to dobry moment, żeby je zamówić.

    Ramki Alfaholicy

    Szczegóły, zdjęcia oraz informacje o zamówieniu znajdziesz tutaj.

    Nie czekaj, bo jak zwykle schodzą szybko.

[Stelvio] DTCM - error

Joseph-S

New
Joined
May 29, 2020
Messages
33
Car
Stelvio
Hello
In Proxi Alignment Procedure - the Info tab turned red and I got an error:

Drive Train Control Node (DTCM) removed

What could be its cause, any suggestions for solving it.
Thank you.
 
Proxi (4.6) probably does not include the DTCM.


I checked carefully - it does include it.
 
Last edited:
4.6 handles it, and even older Proxi versions didn’t have a problem. Joseph-S the error appeared by itself (fuse, etc.) or did you poke around in Proxi? what did you do?
 
Hello
The error appeared by itself; I haven’t touched Proxi yet. Question to epsonix: which fuse and where to look for it, and what else could be.
 
A note I found regarding DTCM:
cite:
"REPAIR PROCEDURE:
WARNING: Install a charger to ensure battery voltage does not drop below 13.2 V. Do not allow charging voltage to exceed 13.5 volts during the flashing process.
WARNING: If this flashing process is interrupted, the flash should be started again.
Check/reprogram DTCM using the latest available software. Detailed instructions for flashing control modules using the wiTECH diagnostic application are available after selecting the “HELP” tab of the application.
Using wiTECH, restore the configuration and align the Proxi. This procedure is available in the Diagnostic Procedures tab located on the home page, Vehicle View, on the wiTECH page.
Delete all DTC codes that may have been set in any module as a result of reprogramming. The wiTECH app will automatically show all DTC codes after flashing and will allow their deletion."
 
Take it easy, since Proxi wasn’t touched, why jump to a reset procedure for Proxi/alignment/flash - for positions 1 and 3 it still has to go to the dealer on WiTECH. Maybe it’s something as simple as a blown fuse or a loose connector.
Joseph-S, do you have any fault codes displayed on the gauges? I ask because I once consulted with a forum member abroad where after some tinkering a mechanic started having issues; on the dashboards there was a message about 4x4 drive unavailable and possibly some others (not sure), I gave him a list of related fuses and he found it. Which ones I don’t remember, would need to dig into schematics which I don’t have time for quickly - just one schematic F16 in the right-hand box of the engine compartment by the window and F03 in the trunk box.

Question, can you even connect to the DTCM? And one more thing, is the car new to you or did you bring it from somewhere else? Maybe someone tried to add Race Mode and I know that in some older firmware the DTCM would trigger the Proxi; in that case a Proxi reset, Proxi, and perhaps an update might be tried (won’t hurt)
 
Last edited:
Hello
Thanks for the interest.
Suggestions from colleague "Epsonix" were spot on - the fuse in the trunk was damaged. Replacing it and everything works.
Case closed.
 
Amortyzatory
Back
Top