• Jeśli chcesz dodać swojej Alfie charakteru i jednocześnie zaznaczyć przynależność do naszej społeczności – to dobry moment, żeby je zamówić.

    Ramki Alfaholicy

    Szczegóły, zdjęcia oraz informacje o zamówieniu znajdziesz tutaj.

    Nie czekaj, bo jak zwykle schodzą szybko.

Check Engine

hddcut

New
Joined
Nov 27, 2013
Messages
10
Car
Alfa Romeo Giulietta 1.4 170 KM TCT
Yesterday, after 4 days in the cold, I started the car. I also had a strong fuel reserve. Practically at zero. I started it without a problem and the check engine came up. The start-stop is inactive and DNA. I went to a station. It warmed up, I refueled. I continued. I gave it a bit of gas and the check engine disappeared.

What do you think? 1.4 TCT 170hp petrol, 2011, 22k miles.

Giulietta 1.4 TCT 170hp petrol, 2011, 22k miles.
 
...What do you think?

Giulietta 1.4 TCT 170hp petrol, 2011, 22k miles.
When you start after a longer stop - the operating conditions of the engine have changed (temperature, ambient pressure, and on top of that oil has drained into the sump), so it’s worth letting the computer finish testing all sensors (the warning lights go out) and only then start. Additionally, in an empty tank condensate water vapor forms (in such weather it should be about 3/4 of the tank), so perhaps the pump pulled in some ice.
 
When you start after a longer stop - the engine operating conditions have changed (temperature, ambient pressure, and on top of that oil has drained into the sump), so it’s worth letting the computer finish testing all sensors (the warning lights go out) and only then start. Additionally, in an empty tank condensate water vapor forms (in such weather it should be about 3/4 of the tank), so perhaps the pump pulled in some ice.


Everything suggests that could have happened. Again the warning light did not appear. I already did about 700 km on the road since that day and it runs like crazy.
 
I have something similar, or I had; Julka stood for 4 days in the deepest frost. This morning I get in, first attempt to start, nothing; second, nothing; all possible errors popped up and something started rasping loudly under the hood. I disconnected the battery, waited a moment, connected again, it started, errors disappeared one by one but it’s idling oddly (exclamation mark in the dash). The engine runs normally, I don’t know what’s going on. It warmed up to 90 and now I’m waiting to see because at some moment the engine produced some strange noises; probably a trip to service if the warning light doesn’t go off by itself. I’d add that it’s flashing in the area where you shift gears, not near the gauges.
 
Last edited:
A blown bulb or a poor electrical contact in one of the fixtures - probably the license plate light - you just need to tap the housing.
 
everything works

- - - Updated - - -

the bulbs, indicators, are flashing

- - - Updated - - -

I would add that the start-stop diode is lit all the time
 
Once I jumped in with a burst of speed and turned the key immediately without waiting for the lights to go out, and it started on three cylinders. Obviously a Christmas-tree on the gauge and lots of errors showed up. I turned it off, waited a moment and started again - all good and zero errors. Second time I swapped seats, so I had to remove the negative from the battery. After reconnecting, all possible sensors failed, including the inclinometer and climate control. Even the airbags didn’t work - errors had to be cleared by the computer, they didn’t disappear by themselves. I don’t know what the time limit is for disconnecting from power.
 
A 45-60 minute jumper of the battery is a standard procedure for clearing errors (they use it even at the dealership). No errors should appear - you just need to calibrate the windows and the steering system. Maybe you did it with the key turned in the igni tion?
 
- when charging the battery for 24 hours, after reconnection there were also no problems.
- standard procedure for steering, windows and waiting 1-2 minutes for climate control stabilization.
- after reconnecting the battery, the climate control module runs tests on flaps and that takes a while.

- I never had problems with too quick starting without waiting for tests to finish.
- but as you all say, nothing wrong with waiting until the check (MIL) appears, because it’s a sign that the body acknowledged all confirmations from the modules.
 
Photos of the terminals for 45-60 minutes is the standard error-clearing procedure (they use it at the dealership too). No errors should appear - you just need to recalibrate the windows and steering system. Maybe you did this with the key turned in the ignition switch?
I was removing seats with cushions and the steering wheel, so I also had to disconnect the air bag. All of that took almost the whole day, and the clamp was off for that long. The key might have been in the ignition during that time, I didn’t pay attention to it - but it certainly wasn’t turned. The fact is that after reconnecting the battery, we had to clear a bunch of errors from the computer.
 
I’ll write here so I don’t litter today: in the morning I open the hood and there’s a squeal from under the hood (there wasn’t any animal there) such a loud creak it was, an attempt to start with zero problems but that sound annoyed me, almost like a cry for help, and it was only -13 did anyone ever encounter something like that
 
[Giulietta 1.4 MA 170KM 2011r 21tys km]
Hello,
Yesterday, returning from work, calmly approaching the lights (after 5 km of smooth driving) Julka began choking, all systems shut down, messages appeared as above. I pulled over to the shoulder, turned off the engine and swore. I restarted the engine, the choking stopped but the “check engine” message kept showing. I parked the car in a warm garage, in the morning after the message there was no trace.

Error codes I read were: P0101, P2299

Maybe it was some organized action?! A month ago my warranty expired ;-(.

Regards,

P.S. I found online descriptions of errors, maybe they’ll be useful to you too: http://www.forum.alfaholicy.org/mit..._obslugi_line_schematy_itp-2.html#post1341025
 
Last edited:
Hello again. Yesterday while calmly driving on the highway. Temp gauge around 110. No antics. The check engine light came on. This morning I checked on the computer and the error appeared:
"-Signal from the electrovalve of the controlling elements uniair for cylinder 2
-intermittent"

Uniair probably means the electronic control system of the cam timing... hmm.
I cleared the error and for now it’s okay. But I’ll push it further on a longer distance.

What do you think?
 
I also had a case related to the check engine light appearing around -10 C, after hooking to the computer and clearing the fault I changed the fuel filter and filled the tank with diesel Arctic Gold at Statoil, the problem went away
 
Gentlemen, I faced a similar issue today. Temperature yesterday and today was similar, about -15 C. The same stretch as yesterday. It starts without any problem. I’m driving calmly for about 10 km, I’m almost home and then: Check Engine, no DNA, no VDC, no Start&Stop, the engine started to choke. I got to the garage, turned off and started again, the check engine is on, DNA doesn’t work, Start&Stop doesn’t work. I drove a few kilometers in two-thirds throttle - no problems, not choking. I parked for a few hours, started again, still check engine and the rest the same. I drove 10 km, turned off - started again: no errors, check engine went off, DNA works. So far I haven’t hooked it up to a computer to read errors. And now tell me - what could it be??? The battery is already weak and that’s why these errors appeared??? Should I expect something bigger?
 
I had something similar shortly after purchase, during the first big frost, the vacuum sensor in the inlet tract – the one next to the battery – went bad (it showed up when reading errors). I sprayed the connector with contact spray and for 6 years the problem never returned. When the ECU goes into fail-safe it disables all systems. It doesn’t hurt to check, though best would be to read the errors to be sure. If the problem occurred while driving and the battery still cranks and starts, I’d say it’s not its fault (except if it periodically has a short in the cell)
 
So far I haven’t read any errors, because it’s cold, dark, and a mess. But the problem disappeared for now and is OK. Today I did 150 km, with no worrying signs. Although the battery is new and already 5 years old, so its parameters are probably not great...
 
Amortyzatory
Back
Top