• Jeśli chcesz dodać swojej Alfie charakteru i jednocześnie zaznaczyć przynależność do naszej społeczności – to dobry moment, żeby je zamówić.

    Ramki Alfaholicy

    Szczegóły, zdjęcia oraz informacje o zamówieniu znajdziesz tutaj.

    Nie czekaj, bo jak zwykle schodzą szybko.

temperature sensor, lambda probe - strange values

Hyoah

New
Joined
Sep 8, 2016
Messages
96
Location
Szczecin
Car
Giulietta 1.4 MA 170, Toyota GT86
Hello,
I plugged Julka into the computer and Multiecuscan showed me not-so-nice results... accordingly I have a few questions for experienced folks:
- AIR temperature always stays at around 30 degrees... does this mean the temperature sensor needs replacement or could something else be going on?, what should it be standardly?
- AFR at 6.5 Kg/h - is this a standard value?
- and the voltage of the lambda sensor before the catalytic converter shows nothing ugly :( ... Interestingly, the lambda status showed as a closed loop, after disconnecting and blowing into the wires... the status changed to an open loop.. but the voltages are still absent - now I don’t know if the lambda is faulty or maybe something with the electrical system.

scan_multiecuscan.jpg
 
In MES one lambda sensor shows nothing, from what I remember. In ScanXL Pro it’s probably OK.
 
This air is being drawn in all the time, literally, 30? Does it vary? On a warm engine, at idle, 30 is quite realistic. Check in the morning, after night, with a cold engine. All temps (air, coolant, and outside) should be +/- 1 degree equal.
 
In MES one lambda sensor shows nothing, from what I remember. In ScanXL Pro it’s probably OK.

Exactly, that’s what puzzled me, because if the lambda wasn’t working there should be some error logged.. and there’s nothing.


This air is being drawn in all the time, literally, 30? Does it vary? On a warm engine, at idle, 30 is quite real.

Checked twice, but always on a warm engine, at idle - I just saw on some scan that someone had 18 degrees in the same conditions. And that’s what puzzles me.
 
Exactly, that’s what puzzled me, because if the lambda wasn’t working there should be some error logged.. and there’s nothing.




Checked twice, but always on a warm engine, at idle - I just saw on some scan that someone had 18 degrees in the same conditions. And that’s what puzzles me.

That someone had 18 and you had 30 isn’t a bad thing.... Check after the night.

Second question, is something not working/wrong with your car? MES sometimes reads some values incorrectly and you shouldn’t treat them as gospel. Some cars show something, others don’t. If the car runs and there are no faults, you shouldn’t worry about it at all.
 
Thanks a lot, if what bubu provided are the correct readings then I don’t need to worry and waste money on a lambda and air sensor - because I have similar readings as in the first log.
 
- I had such results only after replacing the thermostat.
- but I checked earlier with Scan XL Pro (via CAN).
 
Amortyzatory
Back
Top