• Jeśli chcesz dodać swojej Alfie charakteru i jednocześnie zaznaczyć przynależność do naszej społeczności – to dobry moment, żeby je zamówić.

    Ramki Alfaholicy

    Szczegóły, zdjęcia oraz informacje o zamówieniu znajdziesz tutaj.

    Nie czekaj, bo jak zwykle schodzą szybko.

radiator replacement

Stusi

New
Joined
Jul 1, 2014
Messages
47
Car
Mito 1,3 JTDm 90 KM
I was surprised there isn’t such a topic, but I checked the search engine in every possible way and in this case – there isn’t. But let’s get to the point. Has anyone replaced the radiator themselves? There is a lot of work involved and will it be possible without removing the bumper? Because unfortunately my radiator has a small leak. It isn’t leaking too much, because it doesn’t drip under the car, but the radiator is obviously wet and the fluid is evaporating quite intensively, gradually decreasing from the reservoir. By the way, how many liters of coolant are in the system? And I’m also wondering that when the coolant level drops to the point where it’s barely visible in the reservoir, the engine temperature on the gauge doesn’t rise above 90 degrees. In my old 156 when there wasn’t enough coolant the engine instantly ran at 100-110 degrees. It’s a bit surprising and at the same time worrying not to overheat the engine. Maybe there is simply so much coolant in the system that even if you can barely see it in the reservoir it’s enough to cool the engine? Mito- missing. But let’s get to the point. Has anyone replaced the radiator themselves? There’s a lot of work involved and will it be possible without removing the bumper? Because unfortunately my radiator has a small leak. It isn’t leaking too much, because it doesn’t drip under the car, but the radiator is visibly wet and the fluid evaporates quite intensively, gradually decreasing from the reservoir. By the way, how many liters of coolant go into the system? And I’m also wondering that when the coolant level drops so that it’s barely visible in the reservoir, the engine temperature on the gauge doesn’t rise above 90 degrees. In my old 156 when there wasn’t enough coolant the engine immediately reached 100-110 degrees. It’s a bit strange and at the same time worrying not to cook the engine. Could it be that there is simply so much coolant in the system that even if you can barely see it in the reservoir it still suffices to cool the engine? Mito that it might simply be that there is so much coolant in the system that even if you can barely see it in the reservoir, it is still enough to cool the engine?
 
In MiTo fuel is also a problem with the temperature gauge. Recently I had a leak due to a damaged hose, the fluid decreased so much that in the reservoir it was barely visible and the indicator didn’t even move. In a petrol car there are a little under 5 liters, that’s how much I had when replacing the timing belt.
 
That’s what’s weird, because supposedly the temperature sensor works correctly, because gradually as the engine warms up the gauge moves up to 90 C, where it magically stops, even when there is a lack of fluid.
 
Or I don’t know if it’s the problem. 1) Low outside temperatures 2) The fan does its job. I suppose the temperature would rise in traffic in summer.
 
Perhaps low outside temperature does its job, but the engine didn’t warm up enough for the fan to kick in. I’m just a bit worried because I don’t have time to mess with the radiator right now and I’m afraid the engine will start to overheat and the temperature gauge won’t even show it. Maybe it really is riding with such low coolant levels in winter without a problem.
 
I once had a Civic. In that Civic the fan was wired to run constantly from the cabin and there was a constant coolant shortage :) It overheated once, the only time, right in the middle of a hot summer in a traffic jam. Usually it was enough to drive a short distance for the air to cool the engine to about 90C.
 
Thanks, that’s a bit reassuring. It also seemed to me that nothing should happen, but I wanted to hear from other users. If someone could describe how the radiator replacement goes that’d be great :P Because anyway sooner or later I’ll have to deal with it.
 
A long time ago I did it but I’m sure you can’t remove the radiator without removing the bumper, at least because the AC radiator is bolted to the water radiator. You need to remove the bumper and the front crossmember. The radiator itself is on quick-connects, so the disconnection is fairly simple. I’m not sure you can pull the radiator out from the bottom on a jack. To get it out forward you’d have to suction the refrigerant from the AC and disconnect the AC radiators. I removed it with the whole front clip, so I didn’t have to go through that gymnastics. The bumper itself isn’t particularly hard to remove either – the only annoying thing is the fog light mounting tabs on the fenders. It’s worth lining the edges of the fenders with painter’s tape to avoid scratching.
 
Amortyzatory
Back
Top