• Jeśli chcesz dodać swojej Alfie charakteru i jednocześnie zaznaczyć przynależność do naszej społeczności – to dobry moment, żeby je zamówić.

    Ramki Alfaholicy

    Szczegóły, zdjęcia oraz informacje o zamówieniu znajdziesz tutaj.

    Nie czekaj, bo jak zwykle schodzą szybko.

Mario71

Member
Joined
Apr 5, 2016
Messages
56
Location
Piotrków Tryb.
Car
Giulietta 1.4 TB MA 170KM , Stelvio 2.0
Hello.
Today I bought a wireless diagnostic interface VIAKEN V-Skan STN1110. After connecting to Julka, error P1061 appeared with the description unavailable :(. Could someone help me decipher this? Regards.
 
errors P1061-P1064 are a problem with the actuator (the intake valve not opening, misfires, etc.). P1061 is cylinder 1 as the colleague mentioned above. On alfisti.net someone wrote that cleaning the engine and changing the oil to not factory-made helped him - but probably this won't always solve the problem - one error and the causes may be various
 
Thanks for the help. during the last oil change (Castrol Magnatec not factory-made) interesting if it is suitable? The intake manifold wasn’t cleaned and the MA module filter. Hence perhaps this error? In spare time I’ll start cleaning.
 
if it is the 5W40 C3 it probably is suitable - it even has Fiat approval. The intake with this error has nothing to do with it, the filter I think not either although cleaning won’t hurt, I clean it every 2nd oil change (i.e., every 20k km). Haven’t you had a problem with the first cylinder operation, jerking etc? If some varnish has built up from oil (if Selenia was ever changed in the book then surely the grime is there) then this may cause valve sticking, so it wouldn’t hurt pouring some engine cleaner e.g. from Archoil and cleaning the whole lubrication system. If this doesn’t help and the problem worsens it may end up with module replacement in the worst case. Also tell me what year and mileage the car is?
 
I will need to add something and flush the system. 2011, mileage 155k. Quite possible it is dirty. I don’t feel jerking yet. Interestingly, when I drive calmly the check engine lights up and DNA locks. After about 5-6 starts it goes out and the error cannot be cleared.
 
Last edited:
While playing on the computer in the MULTIECUSCAN program I have full control over Julka. What was read from the error code P1061
Oil sensor shows some unreal temperature.


IMG_20160528_232554.jpg
 
Amortyzatory
Back
Top