• Jeśli chcesz dodać swojej Alfie charakteru i jednocześnie zaznaczyć przynależność do naszej społeczności – to dobry moment, żeby je zamówić.

    Ramki Alfaholicy

    Szczegóły, zdjęcia oraz informacje o zamówieniu znajdziesz tutaj.

    Nie czekaj, bo jak zwykle schodzą szybko.

MES - clearing errors - Krakow

Wilq84

New
Joined
Mar 18, 2020
Messages
291
Car
Giulia Veloce Q4
Hey

Some Krakow Alfa Romeo enthusiast could have MES to clear a few errors? I have some gadgets on the computer and the procedure described in the manual doesn’t work well:
ZAREAFDN0K7605258-IMG_4111.jpg
 
but what do you want to erase, did you have an accident? This is the procedure to start the fuel pump after a reset following a collision. where are these errors you’re talking about sitting? if only from disconnecting the battery then they will neutralize after a few engine starts.
 
no, I didn’t have an accident, residues from вмешательство in the ECU....

Now CEL is on, Start&Stop unavailable and fuel cut-off unavailable - three such errors.
It shows me DTC codes: U0415 U040F, which I supposedly can delete with a device, but when I scan again I still have them.
I was advised this procedure to eliminate the error anyway it doesn’t work.

Some people recommend driving around a bit and supposedly the errors should disappear on their own in some cases, I don’t know some adaptation?

PS could the Start/Stop unavailable be related to a low battery charge???:confused:
 
and that whole program they gave you for that ECU reprogrammer is surely compatible with the versions of car ECUs/hardware with a GPF? You have a completely different family of software than mine - mine is G05xx software number, yours is P1xxx or something like that. maybe that’s why you can’t clear the errors - because they are permanent/present and not just occurrences in history (they stop showing on the dash after a while).
S&S unavailable error even pops up (according to a forum buddy), when the hood latch is not closed properly (at least in his case Stelvio), besides the battery there can be many other causes too.
 
yes, they also developed it on cars with GPF and also recommended for my car your bypass as a 'must have'. Yes, exactly I have P1xxx and they did it under that one, so it should be compatible.
They advised to drive 10-20 km at speeds above 100 km/h and the errors should disappear - I still haven’t driven more than 2 km of test miles, so maybe I need to properly warm up the engine and 'push' fuel
 
Last edited:
hmmm, I dunno, drive and you’ll see, at worst let them figure out what the problem is - for now you should follow their instructions
 
ok, topic closed.

The errors went into memory when I turned the ignition on in the morning
 
Amortyzatory
Back
Top