• Jeśli chcesz dodać swojej Alfie charakteru i jednocześnie zaznaczyć przynależność do naszej społeczności – to dobry moment, żeby je zamówić.

    Ramki Alfaholicy

    Szczegóły, zdjęcia oraz informacje o zamówieniu znajdziesz tutaj.

    Nie czekaj, bo jak zwykle schodzą szybko.

Error U1713-2f

bronek90

Member
Joined
Feb 14, 2020
Messages
638
Location
Turek
Car
Stelvio FE LPG; Giulia Veloce `17 LPG
Hello, today on the ride a check engine message popped up, S&S unavailable, otherwise the car was functioning normally. After connecting MES, a fault appeared as in the title. Has anyone encountered this, what could it be? Best regards, Artur.
 
First link from Google:

Alfa-Romeo DTC U1713-2F
Make:
Alfa-Romeo
Code:
U1713-2F
Definition:
ECM (Engine Control Module) EMS (Engine Malfunction System) Failure-Signal Erratic
Description:
This DTC sets when the Powertrain Control Module (PCM) sends a CAN Bus message to the Body Control Module (BCM) indicating DTC(s) exist within the PCM.
Cause:
Powertrain Control Module (Pcm) DTCs
Failure Type:
Signal Erratic
This sub type is used for failures where the signal is momentarily implausible (not long enough for "signal invalid") or discontinuous.
 
Last edited:
Yes, I’ve seen it but the description doesn’t tell me the cause of this fault. I also searched foreign forums and there isn’t much information about this fault, I thought perhaps someone has had the same and knows a solution.
 
Yes, I’ve seen it but the description doesn’t tell me the cause of this fault. I also searched foreign forums and there isn’t much information about this fault, I thought perhaps someone has had the same and knows a solution.
Hi, did you find a solution to this problem? I can’t find anything...
 
So it just faded on its own? Do you think the battery was to blame?
Did you do anything besides charging the battery?
 
Yes, I’ve seen it but the description doesn’t tell me the cause of this fault. I also searched foreign forums and there isn’t much information about this fault, I thought perhaps someone has had the same and knows a solution.
This DTC sets when the Powertrain Control Module (PCM) sends a CAN Bus message to the Body Control Module (BCM) indicating DTC(s) exist within the PCM.
This fault appears on the BCM when there is a fault in the engine computer and it doesn’t mean anything on its own.
 
This error appears on the BCM when you have an engine computer error, and it doesn’t mean anything by itself.

So there is no solution to this problem? Should I look for the issue in the engine? It’s enough to disconnect the negative terminal and the error disappears, only you don’t know for how long.

- - - Updated - - -

It regularly reconnects the battery, since then the error hasn’t come back.

Regularly, you mean how often?
Because I have the impression that when I charge it, two weeks is okay, and then again this error
 
So there is no solution to this problem? Should I look for the issue in the engine? It’s enough to disconnect the negative terminal and the error disappears, only you don’t know for how long.

- - - Updated - - -



Regularly, you mean how often?
Because I have the impression that when I charge it, two weeks is okay, and then again this error

If I drive only in the city, every 2 weeks, if more routes, once a month. Battery since new, 2017. So probably its last legs
 
If I drive only in the city, every 2 weeks, if more routes, once a month. Battery since new, 2017. So probably its last legs

So I just as soon as I charge it, it’s OK for 2 weeks, and if I don’t charge it the error pops up. And apart from this U1713-2F error do you have any other ones?
 
That was 2 years ago, I don’t remember what caused that error. Since then it hasn’t appeared, in autumn I had misfire errors and that error wasn’t there.
 
Did the misfire errors cause a check engine light for you or did you just see occasional misfires? Because I see occasional ones daily in myAlfa but nothing overall happens - and I’m not sure if that’s normal or not.
 
Did the misfire errors cause a check engine light for you or did you just see occasional misfires? Because I see occasional ones daily in myAlfa but nothing overall happens - and I’m not sure if that’s normal or not.

Together with the check, they were P030x errors, so they didn’t point unambiguously to MA. Wife is driving giuliaSince then, when it’s cold or humid outside, before starting I give the engine 20-30 seconds to run and everything is fine.
 
Do you have any errors on the engine control unit, or just that one?

Exactly nothing besides that error, I have another one from the camera but it probably doesn’t affect anything because everything works and the car runs like crazy

- - - Updated - - -

So how will you explain it when I do not have any other errors? And I scan in MES with F12, i.e. DTC errors, and it shows nothing besides that, unless I am doing something wrong
 
Amortyzatory
Back
Top