• Jeśli chcesz dodać swojej Alfie charakteru i jednocześnie zaznaczyć przynależność do naszej społeczności – to dobry moment, żeby je zamówić.

    Ramki Alfaholicy

    Szczegóły, zdjęcia oraz informacje o zamówieniu znajdziesz tutaj.

    Nie czekaj, bo jak zwykle schodzą szybko.

EGR plug - how does the engine react after installing it ???

Junior

New
Joined
Sep 20, 2011
Messages
196
Location
Stanowice k. Rybnika
Car
Alfa Romeo 159 SW 1.9 JTDm 150 KM
Hello ;)
Today I pieced together from a mess the Belle after pulling the intake manifold again and during the previous cleaning I installed a plug that limits exhaust gases at the EGR valve. I started the car, everything was fine, but while driving I press the gas pedal and the car seemingly doesn’t respond, only after some time and it had a very "weak bottom"; only after passing 2-2.5-3 thousand RPM it woke up. I don’t know maybe it’s supposed to be like this; earlier I drove with an intake that didn’t have one swirl flap and now I installed a functional one. The largest instantaneous fuel consumption it showed me was 17-18 l, and earlier it went up to 30 l. No faults.

Has anyone of you installed this plug as well??? How did your cars behave after installation?? Or perhaps this is how it should be and now it’s good, while before the car ran poorly on that other intake, etc.??
 
I have the plug and the engine behavior is completely different.. in my opinion there is better bottom-end than without the plug, so I suspect something is faulty with yours... maybe the EGR?
 
Exactly I thought so too, because I also ordered something similar, also with 4 openings. But now how does that relate to exhaust flow? Does reducing the flow in the EGR not negatively affect engine parameters? For example while driving. Just like you. Isn’t it better to just plug it and disable it and forget?:rolleyes:
 
best to hand the car to professionals I took it to a tuning company and the car runs like gold and friends who installed it themselves it runs like a MOTH .... My opinion is that mechanics is for mechanics and driving for drivers !!!
 
best to hand the car to professionals I took it to a tuning company and the car runs like gold and friends who installed it themselves it runs like a MOTH .... My opinion is that mechanics is for mechanics and driving for drivers !!!
Sometimes it’s good to know - what’s going on in the grass
 
best to hand the car to professionals I took it to a tuning company and the car runs like gold and friends who installed it themselves it runs like a MOTH .... My opinion is that mechanics is for mechanics and driving for drivers !!!
someone has to let these mechanics earn money :D I wonder how much they charged for unscrewing 4 small screws?
 
Hello ;)
Today I pieced together from a mess the Belle after pulling the intake manifold again and during the previous cleaning I installed a plug that limits exhaust gases at the EGR valve. I started the car, everything was fine, but while driving I press the gas pedal and the car seemingly doesn’t respond, only after some time and it had a very "weak bottom"; only after crossing 2-2.5-3 thousand RPM it woke up. I don’t know maybe it’s supposed to be like this; earlier I drove with an intake that didn’t have one swirl flap and now I installed a functional one. The largest instantaneous fuel consumption it showed me was 17-18 l, and earlier it reached up to 30 l. No faults.

Something got stuck there, probably the EGR. Inserting the plug causes only less contamination of the intake, no side effects.
 
This can be done by yourself if you have knowledge of writing ECU control programs - if not then at every decent tuner. After programmatic deactivation you still need to plug the valve with a full plug. In section 147/156/166/GT there is a thread about the EGR and there you’ll find all information
 
Wait I don’t understand. Does Alfa itself produce EGR plugs?? Unless this is not a plug but a throttle, and in its place you insert a perforated plate with holes ...
 
It doesn’t matter whether you install a plug from the OEM or the one from Allegro - the OEM one differs only by having a gasket and being more flexible and costs more. OEM sells it as a service solution to reduce pressure fluctuations and it consists of limiting the reflow of exhaust gases to the engine. I tried both plugs, I even felt that with the Allegro one it runs better. Installing the plug is simple - you can of course have a mechanic do it because access to the EGR is not always easy, though you can’t install it incorrectly. After installation the car should respond better at low end, if it doesn’t respond well it’s probably not a plug issue - maybe the EGR wasn’t defective before? because a plug alone won’t fix the problem if the EGR was faulty.

Completely plugging should be preceded by deactivating the EGR in the software, though not every tuner wants to do that + opinions are divided on this topic.
 
Last edited:
My mistake, indeed it’s more a throttle valve than a plug. Part is original. 7.50 EUR plus shipping. I also have a new EGR, I even got it from London. Soon I’ll start inspecting the inside of the intake as well. And I want to assemble it on a new one.
 
I removed the plug and the car runs much better "at the bottom"... could be the first case where a plug doesn’t help but hinders??? The EGR is clean.
 
A strange symptom. Last week I cleaned and partially plugged the EGR, with a plug and gaskets from Allegro. The change in my case is very noticeable in terms of throttle response... So the opposite symptom is indeed strange...
 
Amortyzatory
Back
Top