Marciarz
New
Hello,
For some time I’ve been observing a loss of power in my Julka, increased fuel consumption, and stumbling at idle, which wasn’t there before. Additionally it seems that the engine started running louder and the car vibrates slightly at idle.
After a visit to the mechanic and plugging into a computer, I got two sporadic errors (configuration fault — probably related to the idle position sensor, and a driveline mode switch fault — probably an issue with attempting to shift to D at high speed). After checking the real values of most parameters, the verdict was OK.
However, after checking the real values of the lambda sensor, sensor 2, the computer indicated much too low voltage, fluctuating around 100 mV — at high revs (instead of the supposed correct range of 500-800 mV). At idle the sensor reading was around 140 mV. Since the computer had not shown any faults from the lambda sensor or others related, it was concluded that this indicates a clogged catalytic converter - though it was recommended the catalyst be cleaned/regenerated as soon as possible.
Has anyone encountered a similar situation? What are the solutions? Is it really the catalyst or perhaps the sensor? Or maybe it’s just an electronics connection issue? the real values of the lambda sensor 2, the computer indicated much too low voltage fluctuating around 100 mV - at high revs (instead of the supposedly correct range of 500-800 mV). At idle the sensor reading was around 140 mV.
Because the computer has not shown any faults so far from the lambda sensor or others related, it was concluded that this indicates a clogged catalytic converter - while it was recommended cleaning/regenerating the catalytic converter as soon as possible.
Has anyone encountered a similar situation? What are the solutions? Is it really the catalytic converter or perhaps the sensor? Or maybe just an electronics connection issue?
For some time I’ve been observing a loss of power in my Julka, increased fuel consumption, and stumbling at idle, which wasn’t there before. Additionally it seems that the engine started running louder and the car vibrates slightly at idle.
After a visit to the mechanic and plugging into a computer, I got two sporadic errors (configuration fault — probably related to the idle position sensor, and a driveline mode switch fault — probably an issue with attempting to shift to D at high speed). After checking the real values of most parameters, the verdict was OK.
However, after checking the real values of the lambda sensor, sensor 2, the computer indicated much too low voltage, fluctuating around 100 mV — at high revs (instead of the supposed correct range of 500-800 mV). At idle the sensor reading was around 140 mV. Since the computer had not shown any faults from the lambda sensor or others related, it was concluded that this indicates a clogged catalytic converter - though it was recommended the catalyst be cleaned/regenerated as soon as possible.
Has anyone encountered a similar situation? What are the solutions? Is it really the catalyst or perhaps the sensor? Or maybe it’s just an electronics connection issue? the real values of the lambda sensor 2, the computer indicated much too low voltage fluctuating around 100 mV - at high revs (instead of the supposedly correct range of 500-800 mV). At idle the sensor reading was around 140 mV.
Because the computer has not shown any faults so far from the lambda sensor or others related, it was concluded that this indicates a clogged catalytic converter - while it was recommended cleaning/regenerating the catalytic converter as soon as possible.
Has anyone encountered a similar situation? What are the solutions? Is it really the catalytic converter or perhaps the sensor? Or maybe just an electronics connection issue?
