• Jeśli chcesz dodać swojej Alfie charakteru i jednocześnie zaznaczyć przynależność do naszej społeczności – to dobry moment, żeby je zamówić.

    Ramki Alfaholicy

    Szczegóły, zdjęcia oraz informacje o zamówieniu znajdziesz tutaj.

    Nie czekaj, bo jak zwykle schodzą szybko.

1.6 MultiJet 105 problem with the lambda sensor

Ricambi

New
Joined
Oct 24, 2012
Messages
100
Location
Poznań
Car
Croma JTDm 150 Emotion, Doblo 1,6 MJ Emotion
I have a problem with heating the lambda sensor, issue on the ground side. I want to determine whether the problem is on the loom side or on the ECU side. Does anyone have an electrical diagram or a pinout of the ECU for the 1.6 MJ 105HP engine? Or does anyone know which pin in the ECU is responsible for controlling the lambda sensor heater?
 
I found something like this on my diagram, K040 is the lambda
"The oxygen sensor K040 sends signals to pins 64, 65 and 87 of connector A of M010 while pin 86 supplies a reference earth. Sensor K040 is heated by a resistance to ensure it
works efficiently even when cold. The resistance is supplied by the line for fuse F11 of B001 and receives an earth signal from pin 51 of connector A of control unit M010."
1.6_JTDM.jpg
 
I found something like this on my diagram, K040 is the lambda
"The oxygen sensor K040 sends signals to pins 64, 65 and 87 of connector A of M010 while pin 86 supplies a reference earth. Sensor K040 is heated by a resistance to ensure it
works efficiently even when cold. The resistance is supplied by the line for fuse F11 of B001 and receives an earth signal from pin 51 of connector A of control unit M010."
View attachment 285806

Thank you very much, you saved me a lot of time. Do you happen to know if these pins are labeled somewhere in the socket, from which side to count?

I also have a request for a link to the source material, in the schematic you can see other sensors/devices connected to the ECU, I’d like to read more.
 
Last edited:
Some time ago I found such things on a Chomikú. I can’t see the pinout on my end :/
 
I measured the looms and they are fine, unfortunately the controller is shot. I’ll try to disassemble and see which actuator element is responsible for controlling the heater, maybe I can replace it and the problem will go away.
 
Amortyzatory
Back
Top