• Jeśli chcesz dodać swojej Alfie charakteru i jednocześnie zaznaczyć przynależność do naszej społeczności – to dobry moment, żeby je zamówić.

    Ramki Alfaholicy

    Szczegóły, zdjęcia oraz informacje o zamówieniu znajdziesz tutaj.

    Nie czekaj, bo jak zwykle schodzą szybko.

[Giulietta] telematics node (CTM)

piotr_147

Member
Joined
May 22, 2010
Messages
195
Location
mielno
Car
Alfa 155 v6 ,Giulia Q4
Hi there, as the title says I have a problem with the Proxi procedure. The CTM thematic node error keeps popping up: EOL failed. Symptoms: flickering gauge and the passenger airbag turned off, which could be reactivated. The whole situation started after a discharged battery, which turned out to need replacement; after installing a new battery, problems appeared. I have two Giuliettas in the family, 2.0 JTD, including one automatic. Bad luck that in both cars the batteries died and in both a similar error appeared.
 
First, delete all errors in all possible modules, and when it’s clean, run Proxi.
 
I erased all errors and repeated proxy but no effect, BLUE&ME system also stopped working. Question is: did the BLUE&ME module fail, or is it enough to restore the software for this module? A constant error is visible B10AA-55 module: proxi configuration control.
 
What are you using for that?
 
Alfa OBD or set the interface in MES to high speed. You can also unplug the battery and try again.
 
I didn’t fix it; I tried to do proxy in various ways but no result, maybe only a service at an authorized dealer remains.
 
Try choosing a Fiat Punto from a similar year. When I added cruise control, proxy only worked after I connected as Fiat. The body in Alfa vs Fiat is a different matter.
 
I had a similar problem when my B&M module failed. When I replaced it with another one, the proxy error kept popping up. First I disconnected the module completely, performed alignment as if I didn’t have B&M. After successful alignment, I connected the module and on the next proxy I managed to add it.
 
I had a similar problem when my B&M module failed. When I replaced it with another one, the proxy error kept popping up. First I disconnected the module completely, did the alignment as if I didn't have B&M. After that successful alignment, I connected the module and on the next proxy I managed to add it.

I tried your method but with no result. additionally it turns out that the new battery "does not hold" now I'll try after replacing the battery, but I suspect that due to voltage drops the B&M module failed and probably it will not be possible without replacing it. only I wonder that this happened to two Alfa cars almost simultaneously. Maybe it's just a run of bad luck, because hundreds of times I disconnected the battery and nothing ever happened.
 
it seems that my battery is rather good; I found a left-side current draw under fuse F36, which also has the B&M connected, but I don't know what else is under that fuse. Everywhere they list +30 I don't know what that means, maybe someone knows what else is under F36. There's also a symptom that sometimes when you lay something light on the passenger seat the passenger airbag turns off; maybe there's some short there?
 
Amortyzatory
Back
Top