Piotrek1983
Member
Some time ago in my wife's car (Mito 1.4TB, 5-speed gearbox) there was a sporadic problem with a lack of reverse sensors. I thought the problem was with the sensor module, so I bought a new one for a little money and replaced it. Unfortunately the problem returned, so I started looking deeper. I quickly found the cause - the module is powered from the reverse lights, no power to the bulb = no sensors. Wires checked, everything ok, suspicion fell on the sensor. After unscrewing it from the gearbox it turned out that the "nub" is pressed into the housing and jams in that position, not giving a signal. A bit of tricks like WD-40, cleaning everything, and for a while it was ok, but the problem came back. I bought a new reverse sensor, installed it (annoying access without removing the engine cover). It worked for a while and the same again. Sometimes the reverse light comes on when you lightly push the lever forward after engaging reverse, sometimes not (in this gearbox reverse is "to the right and back"). Has anyone of you encountered a similar problem? Should the reverse sensor have a spacer? The old one was removed and the new ones did not have one, but maybe there should be something there? My suspicion is that the gearbox presses the sensor too hard and it goes beyond its operating point, at the extreme it locks at the end of travel. A spacer might help here, but perhaps someone has dealt with this topic before?
