• Jeśli chcesz dodać swojej Alfie charakteru i jednocześnie zaznaczyć przynależność do naszej społeczności – to dobry moment, żeby je zamówić.

    Ramki Alfaholicy

    Szczegóły, zdjęcia oraz informacje o zamówieniu znajdziesz tutaj.

    Nie czekaj, bo jak zwykle schodzą szybko.

Recurring computer errors

MarcinBB

New
Joined
Apr 1, 2015
Messages
3
Car
Alfa romeo Mito 1.3 95 KM Distinctive
Hello everyone, for some time I’ve had a problem with recurring computer errors, namely the ABS, EBD, and Hill Holder systems don’t work. The DNA system doesn’t work either. After a visit to a friend of mine who is an electronics repairman who services several new ARs, he stated that the battery needed replacement. After replacing it with one dedicated to the Start and Stop system, the errors were erased, but unfortunately they return about every other day and over time they disappear on their own, and so on in a loop:( has anyone else encountered a similar problem, thanks in advance for help:)
 
I’m afraid that’s not enough information. You need to plug it into a computer (e.g., with MES) and see exactly what error code it throws. In other words, read the error codes. I assume that since this friend cleared them, he knows what it’s about.
 
And is this new battery charged properly?
 
Hi, the battery before replacement was tested and had perfect parameters. Is it with Mito the Start and Stop system, is it necessary to maintain voltage during replacement? and its subsequent coding?
 
Hi, the battery before replacement was tested and had perfect parameters. Is it with Mito the Start and Stop system, is it necessary to maintain voltage during replacement? and its subsequent coding?

I suggest every time after starting the engine to turn off the start-stop system, in the meantime erase the errors and drive without an active system, of course turning it off again after the first start of the engine. Then you’ll see whether the errors will recur. Your problem may be related to the car not handling the power receivers due to high load.
 
I hope there hasn’t been any permanent damage to the control unit, because it turns out I bought the car with a wrong battery installed, except that a friend auto-electrician says problems can appear after half a year of use. Today, a repeat in the morning when starting—the systems don’t work; after another starting, until the end of the day there are zero errors, everything is fine. All that remains is to go to the Fiat dealership; maybe they’ve seen such cases and can offer something.
 
In every modern computer-controlled car, a stable voltage from the battery is the foundation for the operation of all electronics – all the errors that sometimes pop up without reason should begin with verifying the battery's state. In my opinion, the battery didn’t damage anything; it was just providing too low voltage, and the electronics translated that into system errors, which at such a moment signaled a fault. It’s important that after installing a new battery you perform the calibration described in the car’s user manual; then you’ll have a few fewer odd errors at startup as well. Drive for a while and then see if there’s any point in going back to that service. If the errors stop, in my opinion there’s no need to spend more money.
 
Amortyzatory
Back
Top