• Jeśli chcesz dodać swojej Alfie charakteru i jednocześnie zaznaczyć przynależność do naszej społeczności – to dobry moment, żeby je zamówić.

    Ramki Alfaholicy

    Szczegóły, zdjęcia oraz informacje o zamówieniu znajdziesz tutaj.

    Nie czekaj, bo jak zwykle schodzą szybko.

Problem with the engine.

pyszny

New
Joined
Jun 6, 2023
Messages
2
Car
Alfa Romeo MiTo 1.4 MultiAir 105hp
Hi, unfortunately in the morning when I wanted to go to work, the car decided to show its moods. mito Generally it’s a 1.4 MultiAir 105 hp petrol. The first problem appeared already at starting; it always started instantly, but today the starter had to work a bit and that’s where it began. At idle over a thousand RPM, and the engine sound, well - like a diesel. It clatters badly and the engine itself trembles noticeably. I decided to try to drive and that was a mistake. At the first lights, after pressing the throttle up to 3,000 RPM, a check engine appeared along with a yellow exclamation mark in a triangle. The engine lost power, and the sound reminded me of a Ursus tractor. A nasty knocking and rattling. I pulled into a parking lot and turned off the engine. After about 5 minutes I decided to start it again and see under the hood what’s going on… And surprise! It started instantly, engine knocking subsided, idle RPM returned to normal and the indicators went out. After a moment I decided to try to get it back to my own parking lot. It managed, and on the way back there were no contraindications. The engine started running nicely, indicators didn’t light up, it was as if it repaired itself. I’ll add, it was still running normally yesterday and nothing happened. MiTo It started up instantly, engine knocking ceased, idle RPM returned to normal and the indicators went out. After a moment I decided to try to bring it back even to my own parking lot. It made it, and during the return trip there were no objections whatsoever. The engine began to run nicely, indicators didn’t come on, just as if it had repaired itself. I should add that yesterday it was driving normally and nothing happened. What would you advise in this situation, go to the mechanic right away or wait a bit more? What do you think could be the cause of such a temporary failure?
 
Typical example of a lack of knowledge about Multi, if the engine starts and runs like a tractor you wait until it stops, then you drive. If you do the same thing again as last time you’ve got an actuator to replace.
 
If it ever happens again, you can try turning the engine off and starting it again (even without a long wait). Do not drive. I’ve had it similar three or four times, always after restarting the engine ran evenly and normally. And between that uneven running and the next uneven running - I think it could be after 20-30 thousand kilometers as well. As DmX writes, absolutely do not drive it, because you will 'misadjust' the actuator.
 
Update on the situation. I went to a mechanic, after connecting to a computer it turned out that ignition didn’t ignite on the first cylinder and the engine was running on three. The cause is unknown, generally everything is fine now.
 
Amortyzatory
Back
Top