• Jeśli chcesz dodać swojej Alfie charakteru i jednocześnie zaznaczyć przynależność do naszej społeczności – to dobry moment, żeby je zamówić.

    Ramki Alfaholicy

    Szczegóły, zdjęcia oraz informacje o zamówieniu znajdziesz tutaj.

    Nie czekaj, bo jak zwykle schodzą szybko.

Increase in engine temperature.

Annik

Member
Joined
Oct 30, 2011
Messages
351
Location
Łomża
Car
Giulia VELOCE Q4 MY20
Hello everyone, this weekend it was still hot and my wife, standing in a small traffic jam at the lights, got from the Alfa a message "engine high temperature, shut off" or something like that. Then suddenly the gauge jumped to the max. She pulled over to the shoulder, turned off the engine. After a moment she started it again and it was fine. Later, while driving 20 km, such a situation occurred again, also in traffic.
I checked with MES:
- radiator/fan relays 1st and 2nd gear – work;
- temperature gauge test – worked correctly;
There were no errors.
The coolant and air temperature sensor show -48°C to the ECU on a warm and cold engine;
I checked the voltage at the coolant sensor plug (in the thermostat) it is 4.9 V
I bought a new sensor - connected it without threading it in - no change, still -48°C
Despite the air conditioning being on, the fan does not turn on immediately after start, only sometimes starts
In 1st gear for a moment and it shuts off.
I have no idea what’s wrong?
Have you ever had such a case? Where to look for the cause?

DF
 
Annik
Look for damage in the wiring.
Did you measure the voltage between the pins or pin and the engine ground?
Did you unplug the air temperature sensor? The so-called MAP sensor.
 
Last edited:
Measured between the pins.
The wiring seems not damaged. Everything is in the original condition.
I have doubts about there being two coolant sensors. After unplugging the one by the thermostat, the gauge on the dashboard also did not show a value and the car, despite the temperature rising, held 1200 rpm – as if cold.
After reconnecting the plug to the sensor, the temperature reading appeared on the gauges (in MES continuously -48°C) and the engine operation returned to normal, i.e., the rpm dropped to 850.
I cleaned the contacts, removed and cut the thermistor near the cooling radiator and so far, knock on wood, everything runs, the fan also turns on.
However, not having a diagnosis still worries me.

DF
 
But does the ECU still see -48?
 
I would unplug the ECU and check the wires from the sensor.
And since it also gives you nonsense about the air temperature, I would check those too.
 
I don’t know if we understand each other.
The sensor and its wires from the thermostat that feed it work. Checked.
Is there any other sensor?

DF

Sent from my SM-A530F using Tapatalka
 
You don’t have that certainty.
Trace the cables from the ECU plug to the sensors and when you are 100% sure they are working, probably you will have to replace the ECU.
Two sensors at once isn’t a coincidence either you have a wiring harness issue or an ECU.
 
Let me ask a simple question - where is the second temperature sensor located? Giulietta 1.4 TB with 170 HP? If it exists.
One is in the thermostat. It provides the signal to the temperature gauge on the dashboard and probably to the ECU (after unplugging, despite the temperature rising, the engine rpm does not drop – it runs as if cold)
I traced the schematics in the Eper and didn’t find any second sensor anywhere.
Maybe there is only one

DF
 
There is one and in the diagram it shows that it is connected directly to the ECU
So the instrument cluster probably gets info via CAN from the ECU.
Maybe try resetting it / ECU /
 
Last edited:
The coolant and air temperature sensor show -48°C to the ECU on both warm and cold engine;

That’s how you wrote it.
Does the air still show -48?
Have you checked in MES what temperature the gauge shows in the gauges tab?
 
Amortyzatory
Back
Top