• Jeśli chcesz dodać swojej Alfie charakteru i jednocześnie zaznaczyć przynależność do naszej społeczności – to dobry moment, żeby je zamówić.

    Ramki Alfaholicy

    Szczegóły, zdjęcia oraz informacje o zamówieniu znajdziesz tutaj.

    Nie czekaj, bo jak zwykle schodzą szybko.

Headlight washers - fluid level sensor

tygrysio

New
Joined
Jan 21, 2011
Messages
628
Location
01-486 Warsaw PL / 95014 Cupertino CA
Car
Dające Radość z Jazdy
Today I noticed a fairly (at least for me) interesting phenomenon that can be attributed to the windshield washer fluid level sensor :)

So, while driving with lights on in the evening, at some point the headlight washers stopped working (as we know they operate every time the windscreen is sprayed when the lights are on).

The headlights stopped spraying even though the fluid was still readily available (I tried 15 times to the front and about 4 times to the rear) to wash the windshield. I got scared that the headlight washers had "gone bad" - I pulled over, checked, they didn’t extend even though fluid was being delivered to the windshield without a problem.

I should add that you could hear the pump working even though the washer wasn’t extending. The problem disappeared after topping up the fluid (4 liters filled it to the max) and the headlights again started getting their share of the fluid.

For me it’s a nice sign that the fluid is running out :) do you have the same ... as if below a certain fluid level the mechanism no longer extends the washers :)
 
I would bet blindly that the tank is shaped in such a way that the pickup for the washer pump is set a little higher than the pump for the windows, hence this kind of 'priority'. The extension of the washer arms is caused by the fluid pressure (hence this high-pressure pump). It’s the same in a brake fluid reservoir, for example a leak from the clutch actuator won’t cause a lack of fluid in the braking circuit, and that one has its own 'priority' — in other words two circuits
 
There is a gauge in the reservoir; you check the fluid level by removing the basket with the dipstick..... :D
 
Obviously obvious :) By the way, they could install some system that would activate the headlight washers only once every, say, 5 washes of the windshield... or some sensor that would activate them if the wash lever is held longer. I’ve had both solutions in other cars and it saved washer fluid and was very convenient :)
 
When I picked up the car, the service guy told me that there should be at least half a tank of washer fluid for the headlight washers to work.
 
I’ll piggyback onto the topic, tell me how the reservoir is connected to the lines? I have xenons and washers but it seems the hose came off because it doesn’t pour onto the windshield, only fluid under the car. Is that rubber hose connected next to the fuse box with such plastic hose that looks like a corrugated tube?
 
Amortyzatory
Back
Top