• Jeśli chcesz dodać swojej Alfie charakteru i jednocześnie zaznaczyć przynależność do naszej społeczności – to dobry moment, żeby je zamówić.

    Ramki Alfaholicy

    Szczegóły, zdjęcia oraz informacje o zamówieniu znajdziesz tutaj.

    Nie czekaj, bo jak zwykle schodzą szybko.

Errors C1205 and C0074

Omii

New
Joined
Jun 9, 2020
Messages
8
Car
Giulietta QV
Hi there!
Patient AR Giulietta QV, after strong braking on snow and a spin, errors pop up: Steering corrector unavailable see handbook, ASR, VDC, Hill Holder... etc. ABS doesn’t work, steering assist works normally. After turning off and starting the car the errors disappear. Apart from the lights and information nothing else happens. It’s worth noting that with lighter braking you can feel the ABS under the pedal, and with stronger pressing the brakes the errors appear and it shuts off. Battery is new.
Errors from the computer C1205 and C0074.

Has anyone dealt with this?
 
ABS sensor some one is hit?

I don’t remember if it’s in alfaobd or Mes test — test sensors on each wheel, connect to the ABS control unit and see if it shows any nonsense.
 
Last edited:
I checked the wheel sensors on the computer, each of them shows speed normally while driving. Are ABS sensors something separate?
 
if it’s as you write that at the moment of loss of traction the wheels start to wander then nothing else comes to mind besides the ABS control unit or sensors.

does this happen in every mode?
 
yes in every mode, and only at the moment of loss of grip, and sometimes the ABS works - in case of complete loss it throws errors... once more these errors popped up on a roundabout when I had oversteer... and the steering angle sensor? Would disconnecting the steering angle sensor cut power steering?

- - - Updated - - -

I also searched and found something like this: Common Faults: Alfa Romeo Giulietta ABS pump and module failure will cause the ABS warning light to remain constantly illuminated. When using scan tools on the vehicle fault codes may be found for: C1205 - Valve Relay Internal Fault and C0074 - CAN Message Active Torque Request Signal Faulty.

The computer errors and the description on the page match, so could it be this?
 
There is no ABS pump, it’s just a pressure distributor and its dosing (electrovalves) of what gets from the hydraulic pump pressed by the foot and boosted by vacuum
 
Is this about it? allegro.pl/oferta/alfa-romeo-giulietta-pompa-abs-51775126-9768122022
 
Last edited:
Okay, thanks a lot for the help! I’m going to replace it and I’ll let you know if that’s it :)
 
I had the identical problem - after slipping, the car threw C1205 and C0074 errors. The ABS pump was replaced; now the ABS works correctly, but the errors: steering corrector, ASR, VDC, hill holder appear as soon as you turn the key - previously they appeared only when the ABS was supposed to activate

question: is this a calibration/setting issue of the ABS pump or is it faulty? who besides the dealership can sort this out, preferably in Łódź?

note that the ABS pump was replaced with one having a matching part number
 
Last edited:
mes.jpg

graph of 2 braking events during which the car was in a skid. can someone tell me which sensor might be suspected here? the left front sensor behaves differently from the others, because under the orange line the green and red seem to hide?

the ABS pump was replaced, the car showed ABS Failure, after pump replacement it showed EBD Failure, after pump replacement a calibration was performed
 
Amortyzatory
Back
Top