meridian
New
Hello,
Please help explain the causes of errors read from OBDII.
A brief description of how the errors appear.
The first time I noticed any errors appearing was after the coldest night -30 degrees. In the morning the car wouldn’t start, but when it finally did after a short drive, under a shop on the parking lot the errors appeared on the dashboard: Unavailable Start&Stop, Unavailable HillHolder, No steering assist, and No D.N.A. After turning off and restarting the engine everything was fine. I went home, read the errors, but didn’t really worry about them because I thought it was due to cold, frost, etc., and I erased them. That was sometime at the beginning of January.
Since then nothing happened until last week, in the middle of an intersection, but when I was stopped and not moving again errors appeared on the dash: Unavailable Start&Stop, Unavailable HillHolder, No steering assist, and No D.N.A. This time I took a screenshot as in photo 1 but without details, and the errors read: B1067, B1074, B1065, B1047. I erased them and everything was fine. Nothing on the dash is displayed.
Today I plugged in OBDII again and two errors appeared: B1047 and B1074 with descriptions as in the screenshots (I took screen captures from a phone with AlfaOBD). They are related to the Body Computer, but why do they appear? Also worrying is the Error Counter, which probably counts the number of these errors. So please, someone knowledgeable, explain what these errors are and what to do with them. The car drives normally, nothing is happening. Mito 2010 1.4 Multiair 105KM.



Please help explain the causes of errors read from OBDII.
A brief description of how the errors appear.
The first time I noticed any errors appearing was after the coldest night -30 degrees. In the morning the car wouldn’t start, but when it finally did after a short drive, under a shop on the parking lot the errors appeared on the dashboard: Unavailable Start&Stop, Unavailable HillHolder, No steering assist, and No D.N.A. After turning off and restarting the engine everything was fine. I went home, read the errors, but didn’t really worry about them because I thought it was due to cold, frost, etc., and I erased them. That was sometime at the beginning of January.
Since then nothing happened until last week, in the middle of an intersection, but when I was stopped and not moving again errors appeared on the dash: Unavailable Start&Stop, Unavailable HillHolder, No steering assist, and No D.N.A. This time I took a screenshot as in photo 1 but without details, and the errors read: B1067, B1074, B1065, B1047. I erased them and everything was fine. Nothing on the dash is displayed.
Today I plugged in OBDII again and two errors appeared: B1047 and B1074 with descriptions as in the screenshots (I took screen captures from a phone with AlfaOBD). They are related to the Body Computer, but why do they appear? Also worrying is the Error Counter, which probably counts the number of these errors. So please, someone knowledgeable, explain what these errors are and what to do with them. The car drives normally, nothing is happening. Mito 2010 1.4 Multiair 105KM.



