• Jeśli chcesz dodać swojej Alfie charakteru i jednocześnie zaznaczyć przynależność do naszej społeczności – to dobry moment, żeby je zamówić.

    Ramki Alfaholicy

    Szczegóły, zdjęcia oraz informacje o zamówieniu znajdziesz tutaj.

    Nie czekaj, bo jak zwykle schodzą szybko.

PingNoMore

Member
Joined
Aug 16, 2019
Messages
214
Car
Giulietta 1.4 MA 170 KM
Hi,

a few days ago I plugged my Alfa 1.4 Multiair into the MES program. The error P01710-62 appeared.

1.jpg

I started checking possible causes. The first thing I came across was a damaged diaphragm in the EGR valve, I replaced it and it seemed to be ok. Unfortunately the error returned after a few days. MES does not show me the voltage from the sensor before the catalyst, but I can see what the mixture is. I see that it is lean/rich and it changes every moment. From what I read this is the correct behavior of the sensor. However the voltage of the sensor after the catalyst is visible in the image below. In my opinion it looks ok, but the sensor after the catalyst is constantly operating in a lean mixture mode. What could be the cause of such behavior? Left air intake?

W2.jpg

In my opinion it is ok, but the sensor after the catalyst is constantly operating in lean mixture mode

ubogo.jpg

What could be the cause of such behavior? Left air?
 
Do you have LPG? That may be the simplest explanation[emoji6]

Sent from my Mi A2 Lite using Tapatalka
 
I think the problem has been solved. I read here on the forum and on alfaowner.com that for MA engines a software update was released in 2017. I wrote to the dealer and indeed there is one. On Monday I went to the dealership, the engine was given the new software. Today, after checking with MES, there is no fault.
 
I'll dig up the topic.
Giulietta 1.4 Multiair. I get the error P0171-62: mixture too lean, the error is detectable when connected to a computer, the dashboard shows no lamps or messages. For now I’m waiting for a response from the service whether there is a newer engine software and whether an update can be done. I’m starting to look for causes and I was surprised by the exhaust gas temperature of 689 degrees C when cold and the lack of information about the oil temperature.
1. Could any of these two be related to the error?
2. Instead of updating the software at the service, would it be better to go to a tuner for a light software tweak?
3. What else can be checked after plugging in the computer?

- - - Updated - - -

One more thing, is the software update at the service paid?
 
Amortyzatory
Back
Top