Hi,
finally I bought the cable and the yellow adapter, so I could connect to the computer - mainly to check for errors, because the ignition drops out when the engine is cold, but that’s not the point.
Entering BODY and proxy, I saw the message "Lateral acceleration/direction nodal misalignment - REMOVED" - there are no errors on the gauge, it runs normally, and the odometer doesn’t blink. So I have a few concerns and questions about alignment:
1. If I try to perform alignment right now, will the ESP (or whatever this module concerns) stop working?
2. What are the default parameters for "turn signal control" and "alarm country" after alignment? (I don’t have a security code to change it later)
3. Are the parameters in the "Realizations" tab, where the alignment is performed, current parameters? In the "transmission" position, for example, DWUSPRZĘGŁOWA is entered, which isn’t really true.
4. What could go wrong during alignment, if it even succeeds?
finally I bought the cable and the yellow adapter, so I could connect to the computer - mainly to check for errors, because the ignition drops out when the engine is cold, but that’s not the point.
Entering BODY and proxy, I saw the message "Lateral acceleration/direction nodal misalignment - REMOVED" - there are no errors on the gauge, it runs normally, and the odometer doesn’t blink. So I have a few concerns and questions about alignment:
1. If I try to perform alignment right now, will the ESP (or whatever this module concerns) stop working?
2. What are the default parameters for "turn signal control" and "alarm country" after alignment? (I don’t have a security code to change it later)
3. Are the parameters in the "Realizations" tab, where the alignment is performed, current parameters? In the "transmission" position, for example, DWUSPRZĘGŁOWA is entered, which isn’t really true.
4. What could go wrong during alignment, if it even succeeds?
