-
Jeśli chcesz dodać swojej Alfie charakteru i jednocześnie zaznaczyć przynależność do naszej społeczności – to dobry moment, żeby je zamówić.
Szczegóły, zdjęcia oraz informacje o zamówieniu znajdziesz tutaj.
Nie czekaj, bo jak zwykle schodzą szybko.
Strange connector
- Autor wątku Alfettone
- Data rozpoczęcia
danus77
Aktywny
- Rejestracja
- Wrz 16, 2009
- Postów
- 3,363
- Wiek
- 43
- Lokalizacja
- Bełchatów
- Auto
- Alfa Romeo 166 2.4 jtd 20V Sportronic '04r
Hello.
My english is very bad, so you must forgive me. I understand, but i can not write.
Thats connector on your photo should by connected in to the SCB module on the fuses plate on the acu in luggage compartment. I show you in to picture below. If Inertia switch I50 is activated, then SCB module is connected in to ground and the Voltage on some module in car i broken.
Pin 30 of A20 , the actual starter motor, is supplied with voltage directly from the battery via terminal unit A5 . this supply is interrupted by the SCB device for MAXIFUSE box B99 if the inertia switch I50 is operated.
My english is very bad, so you must forgive me. I understand, but i can not write.
Thats connector on your photo should by connected in to the SCB module on the fuses plate on the acu in luggage compartment. I show you in to picture below. If Inertia switch I50 is activated, then SCB module is connected in to ground and the Voltage on some module in car i broken.
Pin 30 of A20 , the actual starter motor, is supplied with voltage directly from the battery via terminal unit A5 . this supply is interrupted by the SCB device for MAXIFUSE box B99 if the inertia switch I50 is operated.
Thank you so much Danus, but you were very clear in the explanation 
, then the photos, sometimes much better than a thousand words.
Now finally I understand perfectly the operation ..... unfortunately, however, on my fuse plate is not present the SBC module, that's why the connector is disconnected!!
, then the photos, sometimes much better than a thousand words.Now finally I understand perfectly the operation ..... unfortunately, however, on my fuse plate is not present the SBC module, that's why the connector is disconnected!!